Pioneer PDA-5001 Mode D'emploi page 14

Installation and Connections
Connection of G ON SYNC analog RGB source
Make G ON SYNC connections for an AV component with
output that has the synchronization signal layered on top
of the green signal.
When connecting to INPUT3
G B R HD VD
(ON SYNC) INPUT3 (H/V SYNC)
On screen setup is necessary after connection.
Please see page 15.
Notes
÷ When making G ON SYNC connections, do not make any
connections to the VD or HD jacks. If connections are made,
the picture may be not displayed normally.
÷ When using a computer connected by the G ON SYNC
connection, on-screen adjustment for G ON SYNC is
necessary (page 16).
Please read your PC's instruction manual throughly.
When connecting to INPUT4
ANALOG OUTPUT
ANALOG
R G B ( (
R G B
INPUT4
On screen setup is necessary after connection.
Please see page 15.
10
<ARE1351> En
75Ωj2.2kΩ
Connection of composite SYNC analog RGB
source
Make composite SYNC connections for a component
with output that has the vertical synchronization signal
layered on top of the horizontal synchronization signal.
When connecting to INPUT3
G B R HD VD
(ON SYNC) INPUT3 (H/V SYNC)
When using INPUT3, set the impedance selector switch
to match the output impedance of the connected
component's synchronization signal.
When the output impedance of the component's
synchronization signal is above 75 Ω, set this switch to
the 2.2 kΩ position.
On-screen setup is necessary after connection.
Please see page 15.
Notes
÷ When making composite SYNC connections, do not connect
anything to the VD jack. If connected to, the picture may not
be displayed properly.
®
÷ On some types of Macintosh
composite SYNC are both output. With this type of
component, please connect using the G ON SYNC connection
(as shown left).
When connecting to INPUT4
ANALOG OUTPUT
ANALOG
R G B ( (
R G B
INPUT4
On-screen setup is necessary after connection.
Please see page 15.
75Ω j 2.2kΩ
components, G ON SYNC and