Part Names And Functions; Connection Panel (Pdp-502Mxe & Pda-5001) - Pioneer PDA-5001 Mode D'emploi

Part Names and Functions

Connection panel (PDP-502MXE &
PDA-5001)
For details regarding a specific connection format, refer to
the page written in parenthesis. Additional descriptions
may be found in the instruction manual included with the
plasma display, PDP-502MXE.
– +
R
SPEAKER
8 Ω – 16 Ω
4
1
AUDIO INPUT (Pin jacks)
Use to obtain sound when INPUT2 (BNC/S) is
selected. Connect the audio output jack of
components connected to INPUT2 (BNC/S) to these
jacks (page 12).
2
AUDIO INPUT (Pin jacks)
Use to obtain sound when INPUT1 (BNC) is selected.
Connect the audio output jack of components
connected to INPUT1 (BNC) to these jacks (page 12).
3
INPUT1 (BNC)
For connection of components that have a composite
video output jack (page 8).
Use the INPUT1 OUT jack to output the video signal
to an external monitor or other component.
Note: The video signal will not be output from the
INPUT1 OUT jack when the main power of the plasma
display is off or in standby mode .
4
SPEAKER (R) terminal
For connection of an external right speaker. Connect a
speaker whose impedance is 8 -16 Ω.
5
AUDIO OUTPUT (Stereo mini jack)
Use to output the audio of the selected source
component connected to this unit.
6
COMBINATION IN/OUT
DO NOT MAKE ANY CONNECTIONS TO THESE
TERMINALS.
These terminals are used in the factory setup.
IN OUT IN OUT
AUDIO OUTPUT COMBINATION CONTROL
5 6 7
R
RS-232C
(INPUT 4) (INPUT 3)
AUDIO INPUT
8 9 0
7
CONTROL IN/OUT
For connection of PIONEER components that bear the
Î mark. Making CONTROL connection enables control
of this unit as a component in a system.
8
RS-232C
DO NOT MAKE ANY CONNECTIONS TO THIS
TERMINAL.
This terminal is used in the factory setup.
9
AUDIO INPUT (Stereo mini jack)
Use to obtain sound when INPUT4 is selected.
Connect the audio output jack of components
connected to INPUT4 to this jack (page 12).
0
AUDIO INPUT (Pin jacks)
Use to obtain sound when INPUT3 is selected.
Connect the audio output jack of components
connected to INPUT3 to these jacks (page 12).
Note: The left audio channel (L) jack is not compatible
with monaural input sources.
-
INPUT4
For connection of a personal computer (PC) or similar
component. Make sure that the connection made
corresponds to the format of the signal output from
the connected component (page 9).
Use the INPUT4 OUTPUT terminal to output the video
signal to an external monitor or other component.
Note: The video signal will not be output from the
INPUT4 OUTPUT terminal when the main power of
the plasma display is off or in standby mode .
INPUT 2 INPUT 1
AUDIO AUDIO VIDEO
R L R L OUT
2 AUDIO IN 1 AUDIO IN OUT 1
1 2 3
ANALOG OUTPUT
– L
R G B
(
ANALOG
INPUT4
R G B
-
<ARE1351> En
IN
IN
(
3