Audio Connections - Pioneer PDA-5001 Mode D'emploi

Installation and Connections

Audio connections

Before making connections, be sure to check that the
audio component's power and the display's main power is
off.
When this unit is connected to the plasma display,
PDP-502MXE, the following audio connections can be
made.
The following jacks and terminals are located on the
plasma display. For details, please refer to the instructions
supplied with the PDP-502MXE.
÷ Speaker terminals
÷ Audio output jack (stereo mini jack (L/R))
÷ INPUT3 AUDIO INPUT jacks (pinjacks (L/R))
÷ INPUT4 AUDIO INPUT jack (stereo mini jack (L/R))
The following audio input jacks are available on this unit:
÷ INPUT1 AUDIO INPUT jacks (pinjacks (L/R))
÷ INPUT2 AUDIO INPUT jacks (pinjacks (L/R))
Audio connection for component connected to
INPUT1 or INPUT2
PDA-5001
2 AUDIO IN 1 AUDIO IN
After video and audio connections are made, the audio
corresponding to the selected video source is output from
both the AUDIO OUTPUT jacks (stereo mini jack) and the
SPEAKER jacks on the plasma display.
12
<ARE1351> En
Video
Audio input jacks
input
INPUT1 Pin jacks (L/R)
Pin jacks (L/R)
INPUT2
Pin jacks (L/R)
INPUT3
Stereo mini jack (L/R)
INPUT4
Note
The left audio input jack (L) is not compatible with monaural input
sources.
When SCART connections are made
When SCART connections are made to INPUT1 and/or
INPUT2, the audio signal is input at the SCART jack, and
therefore it is not necessary to make the audio
connections described on this page.
Sound output
Sound of the selected video
input is output from the
• SPEAKER terminals
• Stereo mini jacks (L/R).