Component Configuration; Windows 2000/Xp Network - Dynex DX-E201 Guide De L'utilisateur

Masquer les pouces Voir aussi pour DX-E201:

Les langues disponibles

All manuals and user guides at all-guides.com

Dynex5x7-multi.book Page 15 Thursday, September 8, 2005 11:07 AM

Component configuration

component configuration

Although this procedure contains instructions for Windows 2000, Windows XP

instructions are very similar. For Windows XP, see your Windows documentation.

After the driver has been installed, you must make some changes to your

network settings:

1 Click Start, Settings, Control Panel, then click Network and Dial-Up

Connections. The Network Connections window opens.

2 Double-click the Local Area Connection icon. The Local Area Connection

Status dialog box opens.

3 Click Properties, then check the components listed in the dialog box to

make sure that you have all of the following components installed:

• Client for Microsoft Networks

• Dynex DX-E201 CardBus PC Card

• NetBEUI

• Internet Protocol (TCP/IP)

4 If any components are missing, click Add to install them. Highlight the

component you need, click Add, then double-click the component that you

need to install. Click Close to exit.

Table des Matières