Stanley Bostitch GF28WW Mode D'emploi page 8

a place where the temperature is less than 40°C.
Do not abuse the cord. Never carry the charger by the
cord or yank it to disconnect it from
●
the mains. Keep the cord away from
heat, oil and sharp edges.
● When the charger is not in use, or
when being maintained and
inspected, disconnect the power
cord of the charger from the
mains.
● To avoid danger, always use only the specified
charger.
● To avoid personal injury, only use the accessories
or attachments recommended in these handling
instructions or in the Stanley Bostitch catalogue.
● Check and confirm that the supply cord and housing
are not damaged before using the charger. If the
supply cord of this charger or housing is damaged,
the charger must be returned to the Stanley
Bostitch authorised service center for the cord or
housing to be replaced. Only the authorised service
center should do these repairs. Stanley Bostitch will
not be responsible for any damages or injuries
caused by unauthorised persons attempting to
repair the tool, or mishandling of the tool.
● To ensure the designed operational integrity of the
power tool and charger, do not remove installed
covers or screws.
● Always use the charger at the voltage specified on
the nameplate.
● Always charge the battery before use.
● Never use a battery other than that specified. Do not
connect a non-tool specific dry cell, or a
rechargeable battery other than that specified or a
car battery to the power tool.
● Do not use a transformer containing a booster.
● Do not charge the battery from an engine, electric
generator or DC power supply.
ADDITIONAL SAFETY EQUIPMENT
EYE PROTECTION which provides protection against
flying particles both from the FRONT and SIDE should
always be worn by the tool operator and others in the
work area when loading, operating or servicing this tool.
Eye protection is required to guard against flying
fasteners and debris, which could cause severe eye
injury. The employer and/or user must ensure that proper
eye protection is worn.
All manuals and user guides at all-guides.com
and other type/s of machinery being used should also be
considered when selecting any personal protection
equipment.
Note: Non-side shielded spectacles and face shields
alone do not provide adequate protection.
CAUTION: ADDITIONAL SAFETY PROTECTION may be
that any necessary hearing protection is provided and
used by the operator and others in the work area. Some
environments will require the use of head protection
equipment. When required, the employer and user must
ensure that head protection is used.
SAFETY PRECAUTIONS – GAS TOOLS
●
●
Eye protection in accordance with
89/686/EEC, and with equal or
greater grade than defined in EN166
should be used. However all aspects
of the operators work, environment
required in some environments. For
example, the working area may
include exposure to noise levels that
can lead to hearing damage. The
employer and user should ensure
Be careful of ignition
and explosions.
This tool must not be used in a
combustible environment or in the
presence of flammable liquids or
gases. This tool produces hot exhaust
gases that may ignite flammable
materials and produces sparks. Since
sparks may fly during nailing, it is dangerous to use
this tool near lacquer, paint, benzine, thinner,
gasoline, gas, adhesives and similar inflammable
substances, as they may ignite or explode. Under no
circumstances should this tool be used in the
vicinity of such inflammable material.
Explosion and fire hazard.
The fuel cell is an aerosol dispenser
with flammable contents. It is a
pressured
propellant will remain in the fuel cell.
Failure to follow instructions may
result in explosion or fire. Keep the
power tool, fuel cells and battery
away from sunshine and from temperatures
exceeding 50°C (120°F). The fuel cell and/or battery
may burst, releasing flammable gas. Do not pierce
or burn the container, even after use. Do not
incinerate, refill, reclaim or recycle the fuel cell. Do
not spray on to a naked flame or any incandescent
material.
container and the