HP OneLam 400 A4 Mode D'emploi page 23

Using the Corner Rounder
The corner rounder is either enclosed as an accessory (OneLam 400 A4) or is fitted on the under-
side of the laminator (OneLam 400 A3).
Caution!
Risk of injury through sharp cutting device!
Do not touch the knife blades in the corner rounder.
1
Remove the corner rounder from the packaging (OneLam 400 A4) or remove the corner
rounder from the holder (OneLam 400 A3).
2
Fit a corner of the paper/pouch in the corner rounder (D).
3
Press the corner rounder together.
4
If necessary, repeat the process on all the corners of the paper/pouch.
Î The corners of the paper/pouch have been rounded.
D
- 23 -
EN