Cleaning The Burner Assembly - Blackstone 1924 Manuel D'utilisation

Model 1924 | Owner's Manual | Care & Maintenance
Section 03

CLEANING THE BURNER ASSEMBLY

Unit burners vary, however these instructions apply to all units. Clean
burner assembly and check burner for damage. If any large cracks or
holes are found, replace burner.
S T E P 0 1
griddle top.
18
Turn gas OFF at control knobs and LP cylinder. Remove
S T E P 0 2
Carefully detach and
remove the burner.
S T E P 0 3
Run a narrow bottle
brush through each burner
tube several times. (Do not use
wire brushes)
Additional Methods Include:
Run a stiff wire bent into a small
hook through each burner tube
several times.
Use an air hose to force air into
burner tube and out burner ports.
Check that air blows through each
hole. (Wear eye protection)
S T E P 0 4
Brush entire outer
surface of burner to remove grime.
S T E P 0 5
Clean any blocked ports
with stiff wire such as an open
paper clip. Then, carefully replace
burners and reattach. Burner
tubes must be reengaged with the
valve openings.
BURNER FL AME CHECK MATCH LIGHTING
INSTRUCTIONS
01. Light burners and rotate knobs
from high to low. When knob is
Before beginning, if your unit uses
at high, flames should be larger
a 20lb. Propane Tank, check for
than when knob is at low.
gas leaks. (Please reference the
Leak Test Instructions section of
02. Perform burner flame check
the Fuel | Propane - 20lb. Tank
by looking below griddle top
chapter.)
on the side of unit to view
burners below.
01. Ensure control knob is in
OFF position.
03. Always check burner flame
before use.
02. Remove griddle top.
If there is a sudden drop or low
03. Light a match (or long lighter)
flame issue, please reference the
no shorter than 11 inches long.
Troubleshooting chapter.
Place the flame on the right or
left side of the burner.
For additional support, see youtube.
com/blackstonegriddles
04. Push in and turn the control
knob to the HIGH position.
Ensure burner lights and
stays lit.
Care & Maintenance | Owner's Manual | Model 1924
Healthy flames might have a few
flickers of yellow color ❶, then a
dark blue color ❷, followed by a
vibrant blue by the burner tube ❸.
❶
❷
❸
19