Problem and alarm code
The appliance does not fill
with water.
The display shows
The appliance does not
drain the water.
The display shows
The anti-flood device is on.
The display shows
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
12.1 The washing and drying results are not satisfactory
Problem
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry water
drops on glasses and dishes.
The dishes are wet.
Refer to "Hints and tips" for
other possible causes.
13. TECHNICAL INFORMATION
Dimensions
All manuals and user guides at all-guides.com
Possible solution
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
.
authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
.
• Close the water tap and contact an Authorised Service
Centre.
.
Possible solution
• The release quantity of rinse aid is too much. Adjust
• The quantity of detergent is too much.
• The released quantity of rinse aid is not sufficient. Ad-
• The quality of the rinse aid can be the cause.
• The programme does not have a drying phase or has
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the multi-tablets can be the cause. Try a
Width / height / depth (mm) 600 / 850 / 625
For alarm codes not described in the
table, contact an Authorised Service
Centre.
the rinse aid selector to a lower position.
just the rinse aid selector to a higher position.
a drying phase with low temperature.
different brand or activate the rinse aid dispenser and
use rinse aid and multi-tablets together.
ENGLISH
35