6. SETTINGS
6.1 Programme selection
mode and user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings
can be changed:
• The level of the water softener
according to the water hardness.
• The activation of the rinse aid
dispenser when you want to use the
Multitab option and the rinse aid
together.
These settings will be saved until you
change them again.
How to set the programme
selection mode
The appliance is in programme selection
mode when the programme duration
flashes in the display.
When you activate the appliance, usually
it is in programme selection mode.
Water hardness
German de-
grees (°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting.
2) Do not use salt at this level.
All manuals and user guides at all-guides.com
French degrees
(°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
However, if this does not happen, you
can set the programme selection mode
in the following way:
Press and hold simultaneously Multitab
and Delay until the appliance is in
programme selection mode.
6.2 The water softener
The water softener removes minerals
from the water supply, which would have
a detrimental effect on the washing
results and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water
in your area. It is important to set the
right level of the water softener to assure
good washing results.
mmol/l
Clarke de-
grees
8.4 - 9.0
58 - 63
7.6 - 8.3
53 - 57
6.5 - 7.5
46 - 52
5.1 - 6.4
36 - 45
4.0 - 5.0
28 - 35
3.3 - 3.9
23 - 27
2.6 - 3.2
18 - 22
1.9 - 2.5
13 - 17
0.7 - 1.8
5 - 12
<0.7
< 5
ENGLISH
27
Water softener lev-
el
10
9
8
7
6
1)
5
4
3
2
2)
1