Working Advice - Bosch PTK 14 E Notice Originale

16 | English
Structural
Material
mm
Hardwood 6
(Beech) 8
10
12
14
–
Softwood 6
(Pine) 8
10
12
14
–
Particle Board 6
8
10
12
14
–
Wood core ply- 6
wood 8
10
12
14
–
Duotac-automatic
With the Duotac-automatic function, two sta-
ples are shot at the same time. Shooting two
staples at the same time prevents tearing out,
e.g., of thin fabrics or foils. The Duatac-function
is not possible when working with nails.
To shoot two staples at the same time, push the
selector switch for Duatac-automatic 8 upward.
To shoot one stapel or one nail, push the selec-
tor switch for Duatac-automatic 8 downward.
1 609 929 S63 | (19.3.09)
All manuals and user guides at all-guides.com
Position of
Thumbwheel
2
mm
– 3 4
– 3– 4 4
– 4 5
– 4 5
– 4– 5 5–6
14 6 –
– 1 2
– 2 2–3
– 2–3 3
– 3 3– 4
– 3 4
14 3 –
– 2–3 4
– 3–4 4
– 3– 4 4
– 4 5
– 4 5–6
14 4 –
– 2 4
– 3 4
– 3 4–5
– 3–4 5
– 3–4 5
14 4 –

Working Advice

This machine is not suitable for working
with 19 mm staples. Therefore, do not use
the machine to fasten ceiling panelling with
profiled wood or grooves.
Avoid blank shots in order to reduce the wear of
the impact striker.
The machine is designed only for intermittent
operation and will warm up with continuous
use. The tacking force is reduced as a result of
heating up. Therefore, allow the machine to cool
off after 15 minutes (maximum) of continuous
operation.
Stapler Plate (see figure B)
With the stapler plate 13, materials with a thick-
ness of up to 8 mm, such as notepads, seminary
paperwork, thin-walled pressboard or fabrics,
can be stapled.
Depending on the click-on position of the sta-
pler plate 13, the stapler tips are bent toward
the inside or outside.
The data in the following table are recommend-
ed values. Determine the settings for double-
staple application (Duotac) through practical
testing. The staples used must be 3–4 mm long-
er than the thickness of the material.
Staple length (mm)
Material thickness
(mm)
Position of Thumb-
wheel 2
– Stapling paper
– Stapling fabric
Support Foot (see figure B)
The support foot 12 enables exact vertical
placement of the machine.
Spacer Clamp (see figure C)
The spacer clamp 14 enables tacking of sta-
ples/nails with consistent clearance to the
workpiece edges. The variable possibilities for
clicking on allows for many clearance levels.
6 8 10 12
3 4 6 8
3 3–4 5 6
1 2 2–3 3
Bosch Power Tools