Starting Operation; Working Advice - Bosch PTK 3,6 LI Notice Originale

32 | English
Operation

Starting Operation

Switching On and Off
– Firmly place the tacker head 1 against the workpiece first ,until it is
pushed in a few millimetres.
Keep up the contact pressure and briefly press the trigger 5.
Once the staple has been completely driven in, release the trigger 5
and lift the tacker head 1 from the workpiece.
The trigger lock, which is connected with the movable tacker head 1, pre-
vents unintentional shot actuation when the trigger 5 is inadvertently
pressed.

Working Advice

 This machine is not suitable for working with 19 mm staples.
Therefore, do not use the machine to fasten ceiling panelling with
profiled wood or grooves.
 When the staple is jammed in the machine, do not hold the ma-
chine by the trigger. When removing a jammed staple, the trigger can
be inadvertently actuated.
Avoid blank shots in order to reduce the wear of the impact striker.
Carefully apply the tacker head 1 to the material being tacked. Soft work-
pieces (e. g. pinewood) can become damaged by applying too much pres-
sure.
Accessories for Tacking Paper
With specific accessories, the cordless tacker can be used for tacking pa-
per.
The accessories are only suitable for the PTK 3,6 LI.
– With the paper tacker 11 up to 60 sheets can be tacked.
– With the booklet maker 12 up to 30 sheets can be tacked in the centre
with two staples, making it into a booklet. The maximum size of the
sheets to be tacked is A4 (210 mm wide). For centre tacking of sheets
of A5 size, positioning marks are available.
Note: Tack staples are stronger than standard staples and are therefore
more difficult to remove from the paper.
1 609 92A 096 | (29.5.13) Bosch Power Tools