Declaration Of Conformity; Starting Operation - Bosch PTK 14 E Notice Originale

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
23.03.2009
Assembly
Loading the Magazine (see figure A)
Before any work on the machine itself, pull
the mains plug.
Use only original Bosch accessories. The
precision components of the tacker, such as
magazine, striker and impact channel, are
adapted for Bosch staples, nails or pins. Oth-
er manufacturers use different steel qualities
and measures.
Press on both sides of the magazine slider 3
and pull out the magazine 11.
Insert the staple strip 10 or the nail strip 9.
Hold the tacker at a slight angle when insert-
ing the nail strip 9, so that the nails face
against the sidewall.
Slide in the magazine 11 until the closure on
the magazine slider 3 engages.
Bosch Power Tools
All manuals and user guides at all-guides.com
Dr. Eckerhard Strötgen
Head of Product
Certification
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Switching On and Off
At first, firmly place the tacker head 7 against
the workpiece until it is pushed in a few millim-
eters. Afterwards, briefly press the trigger 1
and then release again.
The trigger lock, which is connected with the
movable tacker head 7, prevents unintentional
shot actuation when the trigger 1 is inadvertent-
ly pressed.
For rapid working, keep the trigger 1 pressed.
Position the machine and press the tacker head
7 firmly against the workpiece until the shot is
actuated. After the shot, move the tacker to the
next location and press the tacker head 7 firmly
onto the workpiece again.
Hammer-force Preselection
With the thumbwheel for hammer-force prese-
lection 2, it is possible to preselect the required
hammer force in steps.
The required hammer force depends on the
length of the staples or nails, and on the
strength of the material. The optimal hammer-
force setting is best determined through practi-
cal testing.
The data in the following table are recommend-
ed values.
When operating with two staples (Duotac func-
tion), the hammer-force preselection must be
set approx. one level higher with the thum-
bwheel 2.
English | 15
1 609 929 S63 | (19.3.09)