Functional Description - Bosch PTK 14 E Notice Originale

14 | English
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
Intended Use
The machine is intended for tacking of card-
board, insulating material, fabric, foils, leather
and similar materials on surfaces of wood or ma-
terials similar to wood. The machine is not suit-
able for the attachment of wall and ceiling pan-
elling.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Trigger
2 Thumbwheel for hammer-force preselection
3 Magazine slider
4 Latching aperture for support foot
5 Latching aperture for spacer clamp
6 Latching aperture for stapler plate
7 Tacker head
8 Duotac automatic selector switch
9 Nail strip*
10 Staple strip*
1 609 929 S63 | (19.3.09)
All manuals and user guides at all-guides.com
11 Magazine
12 Support foot*
13 Stapler plate*
14 Spacer clamp*
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Technical Data
Noise/Vibration Information
Measured values determined according to
EN 50144.
Typically the A-weighted noise levels of the
product are: Sound pressure level 83 dB(A);
Sound power level 94 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
The hand-arm acceleration is typically below
2.5 m/s
Tacker
Article number
Impact rate
Intermittent operation
Staple width
Staple length
Nails
Magazine capacity,
max.
Weight according to
EPTA-Procedure
01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
2
.
PTK 14 E
0 603 265 2..
-1
min 30
min 15
mm 11.4
mm 6– 14
mm 14
100
kg 1.1
/II
Bosch Power Tools