How To Use - HoMedics UHE-WM130 Mode D'emploi

HOW TO USE

PROGRAMMABLE HUMIDISTAT
MIST TEMPERATURE
MIST OUTPUT LEVEL/
PROGRAMMABLE
HUMIDISTAT SETTING
POWER BUTTON
Plug unit into a 120-volt AC electrical outlet. Press the power
MIST OUTPUT LEVEL
Mist adjusts from the lowest output (1) to the highest output (5). To increase the mist output, press the + button.
The corresponding mist level will be lit on the display. To decrease mist output, press the – button.
MIST TEMPERATURE SETTING
To change the mist temperature from cool to warm mist, press the mist temperature
illuminated on the display. To change the mist temperature from warm to cool mist, press the mist temperature
button again. "COOL" will be illuminated on the display.
NOTE: Once warm mist is selected, it will take approximately 20 minutes to heat up the mist. The warm setting
kills 99.99% Escherichia coli and staphylococcus aureus bacteria in the water reservoir after 40 minutes of
continuous warm mist operation on mist setting 1. Verified by third-party lab testing.
DISPLAY SHOWS:
Programmed Humidity Setting (pictured),
Timer Setting, Warm or Cool Mist
Selection, Mist Output Level, and Clean
Transducer Reminder
TIMER
NIGHT-LIGHT/DISPLAY LIGHT
POWER BUTTON
button to turn unit on.
6
button. "WARM" will be