UNITEC Climate W010 Manuel De L'utilisateur page 9

RADIO-CONTROLLED CLOCK
The unit will start synchronizing the DCF77 sig-
nal after batteries are installed.
The Tower icon (L) will appear on the LCD, and the
waveform representing signal strength will flash
regularly during synchronization. Signal strength level
is indicated in this way:
1. Very weak or No signal (No waveform)
2. Weak (1st waveform flash)
3. Satisfactory (flash up to 2nd waveform)
4. Good (flash up to 3rd waveform)
5. Tower and 3 waveform icons appear fixed (Recep-
tion successful)
6. Tower (L) and 3 waveform icons out (Reception
failure)
If signal level is weak and time reception is not success-
ful, move the unit away the source of interference and
try again in another location with better radio signal.
The R/C clock will have a daily synchronization at
01:00 everyday. If not successful, the R/C clock will
seek for time signal every hour. Each R/C reception
SUNNY PARTLY SUNNY
WEATHER FORECAST WITH STORM ALERT
The built-in precision pressure sensor will read the
atmospheric pressure and calculate the weather
condition (B) of the next 12 hours.
The resolution:
OFFSETTING WEATHER CONDITION
In case the weather forecast (B) deviates from the
existing conditions, you can still change the weather
offset in the way:
1. Hold "CLEAR" 6 button for 3 seconds to enter
the pressure offset mode. The weather icon will
flash.
2. Select the existing weather condition by pressing
"MEM" 5.
3. Press "CLEAR" 6 to confirm and exit.
313514_Manual.indd 9
All manuals and user guides at all-guides.com
CLOUDY
cycle around 3 minutes to 5 minutes. To avoid inter-
ference, the unit will disable the buttons functions
during radio time reception. This is not a defect. But
you can still simply press " – " 4 button to turn off
the radio time reception temporarily.
CALENDAR/TIME SETTING
User can setting the calendar and time manually. Hold
„SET" 2 button for 3 sec to set the calendar / time in
the follow sequence: 12/24hr format -> year -> month
-> day -> hour -> minute -> Zone time offset -> save
and exit.
Press „ + „ 3 / „ - „ 4 button to adjust, „SET" 2
button to comfirm.
(Enter + - 12 hr in hour offset for different time zones,
(Switzerland 1) leave offset to 0 for home time) Press
"SET / ZONE" 2 to select home time and ZONE Time.
C/ F SELECTION on the home unit
Hold "MEM" 5 button 3 seconds to select C and F
RAINY
SNOW ALERT (visible only)
When outdoor temperature of Channel 1 is less than
+4C, the SNOW icon will keep flashing on LCD.
PRESSURE, TEMPERATURE, HUMIDITY
TREND INDICATORS
If value of the outdoor temperature / humidity or pres-
sure has changed, the 3 small arrow icons will indicate
the tendency (A): Rising, Steady, Falling.
MOON PHASE
The current moon phase (N) is displayed automati-
cally.
9
STORMY
English
20.12.12 10:45