Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Descriptions of display-functions
A
Trend / tendency display
B
Wheather forecast symbols
C
Channel number
D
Outdoor temperature
E
Indoor temperature
F
Low battery indicator remote sensor
G
Low battery indicator main unit
H
Indoor humidity
I
Outdoor humidity
J
Day / month display
K
Clock alarm
L
Radio controlled clock
M
Clock display
N
Moonphase
BATTERY INSTALLATION
Home Receiver:
Lift off the battery cover at the back, install 2
pcs AA batteries according to the polarity indicated,
close the battery cover.
Remote Sensor:
Lift off the bracket stand , loose the 4 screws
with a small screwdriver; insert 2 pcs AAA
batteries according to the polarity indicated.
CH button : Slide to CH 1
C/F button : Select viewing C or F
Tx button 9: Press to trigger a manual transmission
After selecting the desired modes, replace the cover
and tighten the 4 screws . The remote sensor is
designed for outdoor use, but please put the remote
sensor avoid direct sunlight, rain drop and chemical.
SET UP:
Enter the Existing Weather Condition into your
Weather Station. Install batteries into the home
unit and it will ask you to enter the existing weather
condition. Press "MEM" 5 to select the weather
condition (Sunny, Partial Sunny, Cloudy, Rainy, and
Stormy), press "CLEAR" 6 to confirm the setting.
The built-in barometer will be automatically offset in
this setting.
English
313514_Manual.indd 8
All manuals and user guides at all-guides.com
A
B
C
D
F
E
G
SET UP WIRELESS THERMOMETER:
After setting up the current weather condition, receiver
will start seeking RF signal to register wireless ther-
mometer.
• For the first installation, always insert batteries to
the home unit and then the remote sensor. Set
Channel 1 for remote sensor.
• Press the "Tx" 9 button on the back of remote
sensor to verify the RF transmission.
• If receiver successfully receive the RF signal, the
outdoor temperature/ humidty (D+I)and the
Channel number (C) will be displayed in the 2nd row
on the LCD.
• When replacing batteries for the remote sensor,
remember to clear the corresponding channel of the
home unit in this way: Select the respective channel
by pressing the "CHANNEL" 1 button, hold the
"CHANNEL" 1 button 3 seconds to clear the
registration.
• When replacing batteries for the home receiver,
please remove batteries of remote sensor and re-
install the batteries.
8
N
M
L
20.12.12 10:45
K
J
I
H
Publicité
Table des Matières
