Electrical Specifications; General Safety Information - Bradley Aerix+ 2922-287300 Mode D'emploi

Description
Warm air hand dryer, powered by a universal brush motor, delivers up to 800 watts of drying power and incorporates an
integrated element for heated air. The dryer controls provide for (3) distinct levels of motor operation (Hi, Med and Low)
and the option of operation with, or without, the heating element. An infrared sensor is used to automatically activate the
dryer. These models are intended for use in commercial, industrial, office and public facility environments.

Electrical Specifications

Table 1
Models Type
2922-287300 Automatic
2922-287400

General Safety Information

DANGER
injury or death from electric shock.
• Always disconnect the power source before servicing or installing the hand dryer.
DANGER
• This hand dryer must be properly grounded (Earthed) for safe operation. An identified ground connection point is
supplied on the hand dryer's wall base.
• We recommend GFCI protection in wet or damp locations or as required by local code.
WARNING
recommendations are not followed.
• Installation and servicing should only be performed by qualified electrical technicians.
• Use only the electrical power (voltage and frequency) specified for the model hand dryer being installed. See Table 1 -
Electrical Specifications.
• Connect the hand dryer to the nearest suitable distribution panel.
• To limit a voltage drop, and insure efficient operation, use No. 12 AWG (4 mm2) wire or larger as required by local
electrical codes.
• Always connect to a branch circuit with circuit breaker or fuse protection with an electrical rating greater than the model
hand dryer's rated amperage shown in Table 1 - Electrical Specifications in accordance with the NEC (National Electrical
Code) and/or CEC (Canadian Electrical Code).
• To avoid a hazard due to inadvertent resetting of the thermal cutout, the hand dryer must not be supplied through an
external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
• Each automatic model hand dryer must have a dedicated circuit.
• Route all field wiring away from moving parts within the hand dryer.
CAUTION
• Follow the mounting height recommendations in Table 2.
• On a stud wall, one side of the hand dryer should be mounted to an existing stud.
Unpacking
1. Remove all packing material. Recycling is recommended.
2. Carefully remove the hand dryer from the shipping carton, using care not to drop the appliance.
3. Inspect carefully for any damage that may have occurred during transit. Check for any loose, missing or damaged
parts. If the hand dryer is damaged, promptly inform the dealer where you purchased it.
07/12/17
Electrical Input
120VAC, 50/ 60Hz
Failure to disconnect the power source before installation or servicing can result in serious
Failure to properly ground this unit could result in severe electrical shock and/or death.
Risk of fire, personal injury or property damage are possible if local codes, or safety
Improper mounting could result in personal injury or property damage.
WWW.RESTROOMDIRECT.COM
Rated Amperage Rated Watts
10A 1200
Bradley P20-200 Rev. B; ECN 17-15-021
2
704 • 937• 2673
Certifications
129 Oakpark Dr., Unit A, Mooresville, NC 28115