Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PRECAUTIONS
1. The dehumidifier shall not operate if the humidity setting is higher than the ambi-
ent humidity.
2. Drain the water in the water storage tank when the water in the tank is full and
the water level indicator light(WF) illuminates. Then install the empty water tank
back to its position, so the unit can continue its operation.
3. When the unit stops, you have to wait for 3 minutes before you can restart the
unit to protect the compressor from damage.
4. The operational temperature range for this unit is 5-35 C°.
5. If the dehumidifier does not start (The „Run" light is blinking or off) or the de-
humidifier makes intermediate stop on unknown reasons, please check the plug
and power supply for poor connection. If the plug and power supply are in normal
condition, wait for 10 minutes and restart the unit (because take about 10 minutes
to reposition). If the unit still does not start in 10 minutes, please contact your local
distributor service station for repair.
6. When the dehumidifier is in operation, the running compressor will produce heat
and make the room temperature higher. That is normal.
Water drainage:
∙
If the water tank is full, then a red light will go on and the appliance will stop wor-
king. Wait ca 15min before the water tank is removed. Residual water can drop into
the water tank at that time. Remove the water tank carefully, that the floater is not
damaged and pour out the water (Fig 1+2).
∙
The water is not suitable for personal usage (drinking, washing etc.).
∙
After the water tank is inserted wait for ca 3min then the appliance can be restar-
ted.
Continuous drainage:
With a pipe (not supplied with the appliance, can be ordered at Steba as an additional
accessory), which is applied to the water out hole (Fig3), the water can be drained into
a sink. Take care that the appliance is not placed lower than the sink. Remove the water
tank and attach the pipe at the water out hole. Insert the water tank carefully again.
Defrost:
At room temperatures bellow 5°C the appliance will defrost. The compressor stops
working, the fan keeps running. At the panel the „Defrost" lamp is on.
Cleaning and maintenance:
∙
Before cleaning the appliance the humidity regulator should be turned to "Off"
and the plug should be pulled out of the socket.
∙
The water tank should be emptied every day. Take care that the floater is not da-
maged. Rinse the tank every 2 weeks with a normal wash-up liquid.
∙
Open every week the filter at the back and pull the filter gently downwards (Fig4). Rin-
se the filter in warm soap water and dry it completely. Re-insert the filter and close it.
∙
Attention: The appliance is heavy!
14
∙
The outer shell should be cleaned with a damp cloth.
∙
When the appliance is not used for quite a while the filter and the water tank
should be cleaned.
∙
Store the appliance in a vertical way.
Failure list
Problem
Dehumidifier is not working
Dehumidifier produces no or only little
water
Vibrating dehumidifier
Disposal:
Packaging disposal:
Do not throw away the package materials. Please put it in the recycling bin.
Gift box: Paper, should be put to the old paper collection point.
Plastic packaging material and foils should be collected in the
special collection containers.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for environmental safe
recycling.
Service and Repair:
If the appliance must be repaired, please get in touch with your trader or with the
manufacturer:
STEBA Elektrogeräte GmbH & Co KG
Pointstr. 2, 96129 Strullendorf / Germany
Distribution-Tel.: 09543 / 449-17 / -18, Service-Tel.: 09543 / 449-44, Fax: 09543 / 449-19
e-Mail: elektro@steba.com Internet: http://www.steba.com
Possible Reason
∙
No power supply (Check Fuse or the
socket)
∙
Water tank is not inserted completely
∙
Check if the floater is in the water
tank.
∙
Air humidity too low
∙
Air inlet or outlet covered or blocked
∙
Doors or windows of the room are
open
∙
Filter full
Floor not plane
∙
Place some foam material bellow the
appliance
15
Publicité
Table des Matières
