Continuous Drainage; Cleaning The Filter - Steba LE 160 Mode D'emploi

DD-TEC16E
DD-TEC16E
COMPONENTS
∙ When the dehumidifier reaches the adjusted value, the compressor will stop wor-
COMPONENTS
king and starts again when the humidity is again above the programmed value.
∙ Keep doors and windows closed of the room which should be dehumidified.
DD-TEC16E
∙ Take care that nothing can drop on the appliance.
∙ During use, the appliance will create warm air.
∙ To run the appliance continuously, turn the humidity regulator to "cont".
COMPONENTS
2. Air speed:
The air speed can be changed, by pressing the button "Speed". In the display "Hi" is
shown for air speed or "Low" for low air speed. The adjusted air speed is shown in
the panel with "High" or "Low" lamp.
3. Timer:
a) When the time should be adjusted, then press the "Timer" button. The time can
be adjusted in steps of one hour from one to 24hours. The „Timer" lamp at the
panel is on.
b) When the time runs out then the appliance will switch off automatically.
c) When the appliance will be switched off by pressing the "Power" button before
the timer runs out, then the rest time of the timer will be deleted.
4. Adjusting the humidity
CONTROL PANEL
CONTROL PANEL
Press the key to set the desired humidity (RH50%,60%,70%,80%AU,CO). The adjus-
ted humidity is shown at the display for a short time. Then the display switches and
the humiditiy of the room is shown. When the room humidity is 3% less than the set
humidity the compressor of the unit will turn off automatically. When the humidity
of the room is getting 3% higher than the set humidity, then the compressor will re-
CONTROL PANEL
start again automatically. If the „Run" lamp is blinking, then the compressor does not
work. The humiditiy in the room is lower than the adjusted value. If the "Run" lamp is
permanently on, then the compressor is working.
Comfort mode (indicate AU in the display)
a) When ambient temperature is below 5, the compressor will stop working.
b) When ambient temperature is at or above 5 and below 20,the appliance will auto-
matically set the humidity level at 60%.
c) When ambient temperature is above 20 and below 27, the appliance will automati-
cally set the humidity level at 55%.
d) When ambient temperature is above 27,the appliance will automatically set the
humidity level at 50
5. TANK FULL
If this indicator (WF) illuminates, it means tank is full of water, and unit will operate
with fan only(The compressor will stop running automatically, until the tank
4
is emptied).
4
12
WATER TANK DRAINAGE
OPTION A
Empty water tank
WATER TANK DRAINAGE
OPTION A
WATER TANK DRAINAGE
OPTION A
Fig. 1
Fig. 1

Continuous drainage

CONTINUOUS WATER DRAINAGE
OPTION B
Fig. 1
CONTINUOUS WATER DRAINAGE
OPTION B
CONTINUOUS WATER DRAINAGE
OPTION B
Tube
Fig. 3
Fig. 3
Fig. 3
DD-TEC16E
DD-TEC16E
DD-TEC16E
Fig. 2
Fig. 2
FILTER CLEANING
Fig. 2
FILTER CLEANING

Cleaning the filter

FILTER CLEANING
Fig. 4
Fig. 4
Fig. 4
5
5
13