Safety Information - Steba LE 160 Mode D'emploi

Masquer les pouces Voir aussi pour LE 160:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1.
Display
2.
Air-outlet
3.
Handle
4.
Front
Display:
Generally
This appliance is for private use only and must not be used commercially. Please read
the instruction manual carefully and keep it at a safe place. When the appliance is
given to another person the instruction manual should be passed to that person, too.
Only use the appliance as described in the instruction manual and pay attention to
the safety information. No liability for damages or accidents will be accepted, which
are caused by not paying attention to the instruction manual.

Safety information

Connect and operate the appliance in accordance with the specifications shown on
the rating label
Do not plug with wet hands.
Do not plug into a socket where several other appliances are plugged in.
10
5.
Back
6.
Pipe-outlet
7.
Watertank
Do not use if the plug cord is damaged or when the power plug does not fit the
socket securely.
Do not modify the parts, or repair the unit by yourself.
Do not use the unit near a flame.
Do not use where children can easily touch the unit, nor let children use the unit by
themselves.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory, or mental capacities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety
Children should be supervised to ensure that they do not play with the appliance or
the packaging.
The appliance is not intended to be operated by means of an external timer or
separate remote control system.
Never pull at the power cord or chafe it over sharp edges.
Never leave the appliance unattended when in use.
The manufacturer is not liable for damage which is occurring due to the usage of
the appliance in a different way as described or a mistake in the handling has been
made.
Place the appliance on a flat, stable, water resisting surface.
The appliance must stand this way that it cannot tip over.
Do not cover the ventilation openings and take care that no curtains etc can be
hindered the air circulation.
In case of overheating, risk of fire! Keep a safety distance of min 60cm to
wet areas (e.g. Shower, bath tubes, sinks) and min 120cm to water taps!
1. Operation:
When the unit is unpacked, place the appliance vertical on the floor and leave it for
12h, that the cooling liquid is bubble free
Take care that the water tank is inserted correctly.
Turn the humidity regulator is turned to "Off"
Plug the appliance in with dry hands.
Ensure that the ventilation openings are open.
Press the ON/OFF button
. The „Hi" lamp is on and the „Run" is blinking. The ca
humiditiy of the room is shown in the display. The dehumidifier is programmed to
start with continuous dehumidification (CO). Important: When the unit is un-
plugged then the appliance will start the next time with the programmed setting.
The light "Operation" is flashing. In the display "Low" is shown, after that the
humidity of the room. The compressor starts working from a humidity higher than
50%.
The compressor is only working when the real humidity in the air is higher than the
adjusted.
The unit is suitable to work at temperatures from 5°C to 31°C.
The humidity performance is depending on the surrounding humidity and tempe-
rature. A good dehumidification is achieved at temperatures higher than 22°C and
a humidity above 70%.
11

Publicité

Table des Matières
loading

Table des Matières