Water Drainage; Cleaning And Maintenance - Steba LE 100 Mode D'emploi

∙ Take care that nothing can drop on the appliance.
∙ During use, the appliance will create warm air.
∙ To run the appliance continuously, turn the humidity regulator to "cont".

Water drainage:

∙ If the water tank is full, then a red light „Tank full" will go on and the appliance will
stop working. Wait ca 15min before the water tank is removed. Residual water can
drop into the water tank at that time. Remove the water tank carefully, that the
floater is not damaged and pour out the water (Fig 1+2).
∙ The water is not suitable for personal usage (drinking, washing etc.).
∙ After the water tank is inserted wait for ca 3min then the appliance can be restar-
ted.
Continuous drainage:
∙ With a pipe (not supplied with the appliance, can be ordered at Steba as an addi-
tional accessory), which is applied to the water out hole (Fig3), the water can be
drained into a sink. Take care that the appliance is not placed lower than the sink.
Remove the water tank and attach the pipe at the water out hole. Insert the water
tank carefully again.
Defrost:
At room temperatures bellow 5°C the appliance will defrost. The compressor stops
working, the fan keeps running. At the panel the „Defrost" lamp is on.

Cleaning and maintenance:

∙ Before cleaning the appliance the humidity regulator should be turned to "Off"
and the plug should be pulled out of the socket.
∙ The water tank should be emptied every day. Take care that the floater is not da-
maged. Rinse the tank every 2 weeks with a normal wash-up liquid.
∙ Open every week the filter at the back and pull the filter gently downwards (Fig4).
Rinse the filter in warm soap water and dry it completely. Re-insert the filter and
close it.
∙ Attention: The appliance is heavy!
∙ The outer shell should be cleaned with a damp cloth.
∙ When the appliance is not used for quite a while the filter and the water tank
should be cleaned.
∙ Store the appliance in a vertical way.
13