Maintaining The Spark Plug; Air Filters; Help In Case Of Malfunction - AL-KO MH360 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 37

Help in case of malfunction

7.2
Changing the gear oil
In general, the gear oil should be changed every
100 working hours (oil viscosity SAE 80).
Oil change
Required oil volume: approx. 0.2 l.
1. Unfasten the oil filler cap on the right-hand
side of the transmission.
2. Drain used oil.
3. Fill with new oil. The oil must be visible at the
filler opening.
4. Close the filler opening with the screw plug.
5. Dispose of used oil in accordance with the
statutory regulations.
7.3

Maintaining the spark plug

NOTE For more detailed information, please
refer to the separate operating instructions for the
engine.
7.4

Air filters

NOTE For more detailed information, please
refer to the separate operating instructions for the
engine.
Malfunction
Engine loses power.
Engine does not start.
Cultivator blades do not
turn
443275_a
Cause
Air filter clogged
Combustion problems
Cultivator blades dirty
Lack of fuel
Poor quality, contaminated
fuel, old fuel in tank
Incorrect starting procedure
Throttle lever in the wrong
position
Defective spark plug
Air filters
V-belt defective
Gearbox damage
Cultivator blade loose
Bowden cable stretched or
loose
7.5
Motor oil change
NOTE For more detailed information, please
refer to the separate operating instructions for the
engine.
7.6
Adjusting Bowden cables
The fine adjustment is made using an adjusting
bolt on the handlebar and on the motor mount.
1. Loosen the locknuts.
2. Readjust with the adjusting bolt.
3. Re-tighten the locknuts.
NOTE The cultivator blades may begin to
turn when the lever is only pressed halfway up.
8 HELP IN CASE OF MALFUNCTION
NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Remedy
Check and clean air filter
Contact a service centre
Clean the cultivator blades
Top up with fuel
Empty tank and fill with fresh fuel
Execute the starting process correctly
Move the throttle lever to the "HARE"
position (MAX)
See motor instructions.
See motor instructions.
Contact a service centre
Contact a service centre
Tighten the cultivator blade.
Adjust Bowden cable
19

Publicité

Table des Matières
loading

Table des Matières