Product Specifications - Permobil ROHO MOSAIC Cushion Manuel D'utilisation

Troubleshooting
For additional assistance, contact your equipment provider, distributor, or Customer Support.
The cushion is not holding air.
Not able to inflate or deflate the
cushion.
The cushion is uncomfortable
or unstable.
The cushion slides on the chair.
The cushion is stiff.
A component is damaged.

Product Specifications

Cushion sizing (all measurements are approximate):
Model W x D in.
1616 16¼ x 16¼
1618 16¼ x 18¼
1717 17¼ x 17¼
1816 18¼ x 16¼
1818 18¼ x 18¼
2018 20¼ x 18¼
Covers and Accessories Compatible with MOSAIC
Not available in all markets. Contact Customer Support.
- ROHO Heavy Duty Cushion Cover
- ROHO Standard Cushion Cover
- ROHO Planar Solid Seat Insert
- ROHO Contour Base
Cushion materials: flame-retardant PVC film (made without DEHP); inflation valve: Zytel
Cover materials: Refer to the instructions provided with the cover.
Cushion expected lifetime: 5 years
ROHO MOSAIC Cushion Operation Manual
Inflate the cushion. Inspect the inflation valve assembly for damage. Confirm that the inflation valve is completely closed.
Look for holes in the cushion. If very small holes or no holes are visible, follow the instructions in the Repair Kit provided with
your product. For damage to the inflation valve assembly, or for large holes or leaks in the cushion, see the Limited Warranty
supplement, or contact Customer Support.
Confirm that the inflation valve is open. Inspect the inflation valve assembly for damage.
Confirm that:
- the inflation valve is in the front, on the left side of the seated individual.
- the cushion is not underinflated or overinflated.
- the cushion cells and the top of the cover are facing up.
- the cushion is centered beneath the individual.
- the cushion is properly sized to the individual.
- the cushion is properly sized to the wheelchair (not applicable to bedside chairs).
Allow the individual at least one hour to adjust to the cushion.
Make sure that the non-skid bottom of the cushion cover is facing away from the individual. Use directional labels on the
cushion and on the cover to orient the cushion. When possible, use hook and loop fasteners to further secure the cushion to
the chair. Hook fasteners are available upon request. Refer to the instructions provided with the cover.
If the cushion has been in temperatures lower than 32° F (0° C) and exhibits unusual stiffness, allow the cushion to warm to
room temperature.
Contact Customer Support for a replacement.
W x D cm
41.5 x 41.5
41.5 x 46.5
44.0 x 44.0
46.5 x 41.5
46.5 x 46.5
51.5 x 46.5
D
W
4
Width (W) and Depth (D) are measured edge
to edge; includes a ½ in. (1 cm) perimeter
Cell Height Range: 2½ - 3 in. (6.5 - 7.5 cm)