Ferm CSM1049 Traduction De La Notice Originale page 9

DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. Lock-off button
2. On/Off switch
3. Saw blade
4. Auxiliary handle
5. Parallel guide
6. Scale for bevel angle
7. Wing bolt for bevel angle
8. Cutting mark, 45°
9. Cutting mark, 0°
10. Wing bolt for parallel guide
11. Handle
12. Dust extraction port
13. Lever for retracting lower guard
14. Upper guard
15. Clamping bolt
16. Clamping flange
17. Baseplate
18. Lower guard
19. Battery unlock button
20. Battery (not included)
21. Spindle lock
22. Wing bolt for depth adjustment
23. Scale for depth adjustment
3. ASSEMBLY
Before any work on the power tool,
remove the battery.
The battery must be charged before first
use.
Inserting the battery into the machine (Fig. B, E)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (20) into the base of the
machine as shown in Fig. E.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine
(Fig. B, E)
1. Push the battery unlock button (19).
2. Pull the battery out of the machine like shown
in Fig. E.
External dust extraction
The vacuum connection (12) allows a vacuum
cleaner to be attached to the machine.
Replacing the saw blade (Fig. A, B)
When mounting the saw blade, wear
protective gloves. Danger of injury when
touching the saw blade.
Only use saw blades that correspond
with the characteristic data given in the
operating instructions.
Do not under any circumstances use
grinding discs as the cutting tool.
For replacing the saw blade, it is best to set the
depth to 0mm and set the bevel angle to 0°.
Afterwards, the machine can be placed on its
side, resting on the motor housing and baseplate.
Removing the saw blade
1. Press and hold the spindle lock (21) button.
2. Loosen the clamping bolt (15) using the hex key
provided, turning in anti-clockwise direction.
3. Remove the clamping bolt (15) and clamping
flange (16).
4. Retract the lower guard (18) by using the lever
(13) and remove the saw blade.
Mounting the saw blade
1. Clean the saw blade and all clamping parts to
be assembled.
2. Retract the lower guard (18) by using the lever
(13) and mount the saw blade. Ensure the
arrow on the saw blade corresponds with the
arrow on the upper guard (14).
3. Mount the clamping flange (16). Ensure the flat
sides of the clamping flange correspond with
the flat sides of the blade shaft. Also make
sure the convex side of the clamping flange is
mounted to the outside.
4. Press and hold the spindle lock (21) button.
5. Mount the clamping bolt (15) using the hex key
provided, turning in clockwise direction.
9