Additional Information - RCA RTB1016WE Manuel De L'utilisateur

Troubleshooting
No surround sound - speakers not working.
• Check to see if system is actually in full 5.1
SURROUND mode - if you see a red "2CH" icon
on your unit's front panel display, the system is
in STEREO mode rather than SURROUND mode. If
current setting is Stereo, the surround speakers
and center speaker will be inactive. Press
SURROUND button in stop mode (BD mode, with
disc playback stopped), then press
to change surround mode from Stereo to 5.1
SURROUND SOUND.
Note: Not all discs, media fi les, or audio sources
provide surround audio, thus lack of audio to
surround speakers may be due to the actual
source being played.
I can't fi nd my fi le in the JPEG listing.
• Make sure the fi le name is valid.
The remote control does not work or works only
intermittently.
• Check that batteries are inserted or change
them.
• Aim the remote control at the unit. The infrared
beam must not be blocked or interrupted.
• Check that the remote control is confi gured to
control the device you are trying to operate with
it.
The subtitles do not appear.
• Check that the BD/DVD disc provides subtitles.
• Refer to the section on how to display subtitles.
The disc menu language is not the correct one.
• The disc menu language has not been set up.
• The language of your choice is not available on
the disc.
I'm using an HDMI cable, but my the video
quality doesn't appear to be very good.
The unit defaults to 480i, in order to have broad
compatibility with TVs, please adjust the unit's video
resolution to that of your TV's using SETUP Menu (to
access, press SETUP button on remote control).
I'm trying to use the analog video output
(yellow jack), however I don't get video on my
TV screen.
Please try the following:
A) Please ensure your TV is set to the appropriate
input.
All manuals and user guides at all-guides.com
B) If using analog video output, the unit's display
UP button
Precautions
Use
• If your unit has been stored in a cool place for any
• The openings located on the top and bottom are
• During thunderstorms, we recommend that you
• This unit is designed for continuous use.
•
• Do not attempt to look inside the unit through the
• This unit is for domestic use only and must not be
• Total or partial copying of recordings protected
EN - 24
resolution must be set to 480i.
connecting to your TV using an HDMI cable, then
adjusting the unit's display setting back to 480i,
then reconnecting to TV using analog AV cable.

Additional Information

length of time, during a journey for example, wait
for about 2 hours before using it.
for ventilation and must not be obstructed.
isolate the unit from the electrical supply so that
it is not damaged by electrical or electromagnetic
surges.
Switching off the unit to standby mode does
not disconnect it from the mains supply. To
completely isolate the equipment, remove the
plug from the mains jack as some components
remain connected to the electrical supply.
If you notice any burning or smoke, disconnect
the unit immediately to avoid any risk of
electrocution.
disc tray opening or any other opening. You may be
electrocuted or exposed to laser radiation.
used for industrial purposes.
by copyright legislation, without the explicit
permission of the holder of the rights,
contravenes current legislation. Copying or
downloading music fi les for sale or any other
business purpose constitutes or could constitute
a violation of copyright law.
Please try