Initial Operation; Working Advice; Maintenance And Service; Maintenance And Cleaning - Bosch GLI 10,8 V-LI Professional Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-1072-004.book Page 15 Thursday, November 29, 2012 1:44 PM
Operation

Initial Operation

Inserting the battery
 Use only original Bosch lithium ion batteries with the voltage listed on the
nameplate of your cordless worklight. Using other batteries can lead to injuries
and pose a fire hazard.
Insert the charged battery 3 into the handle until it can be felt to engage and faces
flush against the handle.
Switching On and Off
 The cordless worklight produces a light beam that emerges from the lamp
head 1.
To start the cordless worklight, press the On/Off switch 2.
To switch off the cordless worklight, press the On/Off switch 2 again.
To save energy, only switch the cordless worklight on when using it.
Protection Against Deep Discharging
The lithium ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.

Working Advice

Belt Clip (see figure B)
With the belt clip 5, the cordless worklight, as an example, can be hooked to a belt.
The user has both hands free and the cordless worklight is always at hand.

Maintenance and Service

Maintenance and Cleaning

When the battery is no longer operative, please refer to an authorised after-sales
service agent for Bosch power tools.
The cordless worklight is maintenance-free and and contains no components that
must be replaced or maintained.
To avoid damage, clean the plastic lens of the cordless worklight only with a dry, soft
cloth. Do not use cleaning agents or solvent.
If the cordless worklight should fail despite the care taken in manufacturing and test-
ing procedures, repair should be carried out by an authorized after-sales service
agent for Bosch power tools.
Bosch Power Tools
English | 15
1 609 92A 00A | (29.11.12)