Initial Operation - Bosch GLI 18V-300 Professional Notice Originale

OBJ_BUCH-3362-001.book Page 15 Wednesday, September 6, 2017 2:04 PM
Cordless Worklight
Recommended chargers
The colour rendition of illuminated objects can be distorted.
* depending on the battery pack being used
** limited performance at temperatures <0 °C
Assembly
Battery Charging (Accessory)
Note: The battery supplied is partially charged. To ensure full capacity of the battery,
completely charge the battery in the battery charger before using your power tool for
the first time.
The lithium-ion battery can be charged at any time without reducing its service life. In-
terrupting the charging procedure does not damage the battery.
The lithium-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.
 Do not continue to press the On/Off switch after the cordless worklight has
been automatically switched off. The battery can be damaged.
To remove the battery 1, press the unlocking button 2 and pull the battery out of the
cordless worklight. Do not exert any force.
Observe the notes for disposal.
Operation

Initial Operation

Inserting the battery
Insert the charged battery 1 into the battery port until it can be felt to engage and is
seated flush.
Switching On and Off
To start the cordless worklight, press the On/Off switch 4.
To switch off the cordless worklight, press the On/Off switch 4 again.
To save energy, only switch the cordless worklight on when using it.
Bosch Power Tools
English | 15
GLI 18V-300
AL 18..
GAL 18..
GAL 3680
1 609 92A 458 | (6.9.17)