Velp Scientifica FOC 120E Manuel D'instructions page 11

Programmable timer for internal lightening (only on FOC 200 IL)
•
Current day and time setting:
➢ Move the sliding switch "B" to the left position ( )
➢ Use the "h" and "m" buttons to set the current hours and minutes, respectively
➢ Use the "1...7" button to set the current week day
1 = Monday, 2 = Tuesday, ..., 7 = Sunday
An arrow on the display indicates the selection
➢ Move the sliding switch "B" to the middle position (RUN).
•
Operating mode selection:
➢ Move the sliding switch "A"
AUTO: the lights will be turned on and off according to the set operating cycle
I: the lights are always on
O: the lights are always off
•
Operating cycle setting:
It is possible to set up to 16 commutations (8 switching ON and 8 switching OFF).
The internal lights will be turned on at switching ON commutation times. Then, they will be turned off at switching
OFF commutation times.
The switching ON commutation are identified with an odd number (1, 3, 5, ..., 15) and the lamp bulb symbol (
The switching OFF commutation are identified with an even number (2, 4, 6, ..., 16).
➢ Move the sliding switch "B" to the right position ( )
➢ Press the "1...7" button to select the week day or a group of days:
1 = Monday, 2 = Tuesday, ..., 7 = Sunday
1 – 5 = From Monday to Friday
6 – 7 = Saturday and Sunday
Arrows on the display indicate the selection.
➢ Use the " " button to select the desired commutation. Then use the "h" and "m" buttons to set the commutation
time
Repeat these steps to set the needed commutations.
NOTE: the commutation identification number is showed in the right part of the display
NOTE: to delete a commutation press the " " and the "
"0:00"
➢ Move the sliding switch "B" to the middle position (RUN).
NOTE: to avoid error, any switching ON commutation should be followed by a switching OFF commutation.
•
Commutation swap function:
When an operating cycle is in progress, by pressing the "
If they are on, they will be switched off and vice versa.
By pressing again the same button, the light status will be restored as set in the operating cycle.
NOTE: the swap works only until the next commutation. Then, it will be cancelled and the operating cycle restored.
A Sliding switch for operating mode selection
B Sliding switch for time and programs setting
C Timer display
D Control buttons
E Reset button
1 – 6 = From Monday to Saturday
1 – 7 = The whole week
" buttons for few seconds. The display will show
" button it is possible to swap the lights status.
11
).