Timer Operations - Aiwa XR-EM50 Mode D'emploi

TIMER OPERATIONS

POWER
6STANDBY/ON
En
s
Sleep timer
Turns off the unit automatically after a specified time.
1 Hold down SHIFT and press SLEEP on the remote
control.
"SLEEP" is displayed.
2 Within 6 seconds, press f or g repeatedly
to set the sleep timer duration.
With each press, the timer duration changes in 5-minute
steps between 5 to 240 minutes. If there is no button input
for 6 seconds, the current setting is entered automatically.
The unit turns off after the selected time.
To check the remaining time until the unit turns off
Hold down SHIFT and press SLEEP on the remote control.
The remaining time is displayed for 6 seconds.
To cancel the sleep timer
Hold down SHIFT and press SLEEP on the remote control
repeatedly so that "SLEEP oFF" is displayed.
16
POWER
TIMER
f,g
TONE
SET
SHIFT
Timer playback
Turns on the unit at a specified time for the specified duration.
Make sure the clock is set correctly.
1 Hold down SHIFT and press TIMER on the remote
control repeatedly so that "5" and "5 PLAY" is
displayed.
2 Within 6 seconds, press SET.
3 Press f or g to set the timer-on time, and
press SET.
Each press changes the time in 1-minute steps.
Holding these buttons down will vary the time in 10-minute
units.
4 Press f or g to select the source, and press
SET.
•For timer play of a CD, select "CD".
•For timer play of a tape, select "TAPE".
•For timer play of a radio broadcast, select "TUNER".
You will select the band later in step 7.
•For timer play of the equipment connected to the AUX
IN jacks, select "AUX (VIDEO or TV)".
5 Press f or g to set the timer-activated
duration, then press SET.
With each press, the timer-activated duration changes in
5-minute steps between 5 to 240 minutes.
SLEEP
6 Press f or g to adjust the volume for timer
playback, and press SET.
The volume level can be adjusted from 0 to 16.
s
7 Prepare the source.
f,g
To play CD, load a disc.
To play a tape, insert the tape.
To play the radio, select the band and tune in the desired
station.
To play external equipment connected to the AUX IN jacks,
set an external timer for the equipment so that its playback
begins at the same time.
8 Press POWER 6STANDBY/ON (POWER) to turn
the unit off.
"5" remains on the display to indicate the timer standby
mode (when ECO mode is deactivated).
At timer-on time, the unit turns on and plays the selected
source. After the specified timer-activated duration, the
unit turns off again.
•To stop timer setting in steps 3 to 6, press s.
Timer standby mode is also canceled.
•Timer playback will not begin unless the unit is turned off
first.
•Connected equipment cannot be turned on or off by the built-
in timer of this unit. Use an external timer.