Safety Instructions - Velleman WB033 Notice D'emploi

1. Introduction
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device
into service. If the device was damaged in transit, do not install or use it and contact your dealer.

2. Safety Instructions

• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• Damage caused by user modifications to the device is not covered by the warranty.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void
the warranty.
• Check the contents prior to assembly. Use proper tools and never use defective or deformed parts
as an improper installation may cause serious injury.
• Any included hardware is for mounting on solid brick, concrete or hard wood battens.
When mounting on wood, do not use any concrete anchors. Do not use any included hardware for
mounting on steel. If uncertain about the nature of the wall or mounting techniques, please
consult an expert.
• Respect the product's max. load specifications. Protect this device from shocks and abuse and
avoid brute force when operating. Check the installation on a bimonthly basis.
• An adequate mounting is essential and falls outside the responsibility of Velleman nv. Respect all
installation and operating directions of the device to be mounted/installed (LCD/plasma display).
• Only use the device at an indoor location, protected from rain, moisture, splashing and dripping
liquids. Make sure the chosen location spot is able to support the weight of the bracket and
screen.
• Keep fingers away from articulations to avoid injury. Keep the device out of reach of children and
unauthorized users at all times.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4. Features
• ultra slim profile: only 14.5mm
• for LED and slim LCD TVs up to 52" (132cm)
• "slide in" design for quick and easy installation
• sliding lateral adjustment: to install the TV in a straight level
• according to: VESA standard 200x100/800x800
5. Overview
Refer to the illustrations on page 2 of this manual.
A left wall plate (1x)
B right wall plate (1x)
C adaptor bracket (2x)
D supporting spacer (2x)
E double-sided adhesive (4x)
F wall template (1x)
M-A M4x10mm (4x)
M-B M4x20mm (4x)
M-C M5x10mm (4x)
M-D M5x20mm (4x)
M-E M6x10mm (4x)
6. Installation
Refer to the illustrations on pages 2, 3, 4 and 5 of this manual.
1a Wooden Support
• Choose an installation spot able to support the weight of the screen.
• It is important that the bracket be mounted on beams and not simply on a panel.
• Use the wall template [F] to mark the hole locations:
o Stick the double sided adhesives [E] to the back of the wall template [F].
o Peel off the protective paper and stick the template to the wall.
o Mark the holes and remove the template.
23/09/2011
All manuals and user guides at all-guides.com
WB033
User manual
6
M-F M6x20mm (4x)
M-G M8x15mm (4x)
M-H M8x30mm (4x)
M-I washer Ø10mm - Ø4.5mm (4x)
M-J washer Ø12mm – Ø5.5mm (4x)
M-K washer Ø16mm – Ø6.3mm (4x)
M-L washer Ø16mm – Ø8.3mm (4x)
M-M plastic spacers Ø14/Ø6x10mm (4x)
M-N plastic spacers Ø15/Ø8x15mm (4x)
W-A ST6.3x55mm (6x)
W-B nylon plugs (6x)
©Velleman nv