Hendi 272404 Mode D'emploi page 7

Patio heater assembly
Assembly instructions
• List of Required Tools: Philip Screwdriver
• Leak Detection Solution one part detergent and
three parts water
• Assemble all nuts and bolts loosely at first. Tight-
en all connections after completion of assembly.
This eases your work and increase the stability of
the appliance.
• Before assembly, make sure all packing material
and any transmit protection must be removed.
STEP 1: Lie down tank housing assembly (K). Open door
and take out all parts.
STEP 3: Unscrews 2pcs Standard screws and washers (BB) from a Support Bar – Lower (F). Insert Support Bar - Upper (E)
to Support Bar - Lower (F) and fix by using 2pcs Standard screws and washers (BB). Repeat this step to connect
left 3sets support bars.
All manuals and user guides at all-guides.com
• Small deviations in equipment may occur. This is
no lack of quality but subject to improvements.
• If any part is missing or damaged, do not attempt
to assembly this product, Contact customer ser-
vice for replacement parts.
• Assembly should be performed on a flat, level,
non-abrasive surface.
• ESTIMATED ASSEMBLY TIME: 45 minutes.
STEP 2: Keep tank housing in lie down position. Fix the
burner assembly (J) to tank housing by using 4pcs
Standard Screws and Washers (BB).
EN
7