Allegion MG600-2 Serie Installation page 4

Installation - Mechanical
1. Inspect the frame header to determine if an angle bracket or filler plate is required.
2. Fold the enclosed mounting template on the dotted line and then mark and drill holes as indicated. Drill four 1/8" (3.2 mm) holes at the locations
marked 'B'.
3. Disassemble the mounting plate from the maglock assembly using the enclosed hex key. Insert 2 screws into the slotted holes and secure the
mounting plate to the doorframe using two of mounting screws. Do not tighten these screws fully until the maglock is properly aligned.
4. Gently tap (2) 3/16" (5mm) spring pins into the rear side of the armature(s). Drill matching (4) 1/4" (6mm) holes on the door to receive these pins.
5. Align armature/strike plate to magnet, and then drill a 5/8" (16mm) hole in door for sexnut and aluminum reinforcement tube for hollow doors.
Using the M8 x 1.25 x 40mm hex head screw and enclosed hex key, mount armature to door using two metal and one rubber washers.
6. Continue to fasten mounting plate to heading using remaining screws. Then, reassemble maglock assembly to mounting plate.
7. Route wiring from the frame through the rectangular holes in the mounting plate and connect to the terminal blocks.
Remove and discard temporary screws from cover plates. Install the four assembly lock screws into the maglock assembly end caps and
8.
cover plate mounting locations.
9. Make sure the armature and strike plate are flexible enough to permit full contact and maximize the hold force.
MOUNTING PLATE
MOUNTING SCREWS
ARMATURE/STRIKE PLATE
SPRING PIN (2)
SEX NUT
B
TEMPORARY
SCREWS
ASSEMBLY
LOCK SCREWS
TUBE
B
(MG600 Shown)
B
ASSEMBLY
LOCK SCREWS
HEX HEAD
SCREW
WASHER
RUBBER WASHER
HEX KEY
WASHER
B
MAGLOCK
ASSEMBLY
MOUNTING PLATE
ASSEMBLY SCREW
ALUMINUM CAPS
© Allegion 2019
47267238 Rev 02/19-a