Switch Positions; Curling Tongs - SEVERIN HAIR CARE LS 0680 Mode D'emploi

reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
■
Children should be supervised to ensure
that they do not play with the appliance.
■
Caution: Keep any packaging materials
well away from children, as they are a
potential source of danger e.g. from
suffocation.
■
No responsibility will be accepted if damage
results from improper use, or if these
instructions are not complied with.
■
This appliance is intended for domestic use
only and not for commercial applications.
■
In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualified
personnel, including the replacement of the
power cord. If repairs are needed, please
send the appliance to one of our customer
service departments. The address can be
found in the appendix to this manual.

Switch positions

The appliance is equipped with a 3-position
switch allowing for the following settings:
Functions:
0 = Off
1 = Half power
2 = Full power
Fitting / removing attachments
Fitting:
Hold the appliance with the switch facing up.
Push the metal studs on the attachment into
the grip body so that they are properly aligned
with the corresponding openings in the
connecting piece. Push the attachment in and
turn the locking ring anti-clockwise to lock.
Removing:
Always allow the attachments to cool down
before taking them off after use. Once
sufficiently cool, turn the locking-ring clockwise
and pull the attachment off.
Operation
Make sure the appliance is used on dry hair
only.
- Fit the desired attachment to the appliance.
- Insert the plug into a wall socket.
- Turn the appliance on. The indicator light
comes on.
- Let the curler heat up for approximately 5
minutes.
- The individual attachments are used as
described below.

- Curling tongs

- Divide the hair into separate strands, grip
the end of a strand with the clamp and
curl it up to the hairline.
The integrated swivel makes it easy to
use the curler in this way.
- Hold the hair curled up for a few
seconds, then open the clamp, hold the
curl and remove the curler gently from
the hair by turning it.
Make sure the hot parts of the curler are
■
kept away from the scalp.
- Let the hair cool down sufficiently before
brushing it out.
- Round brush, spiral curler attachment
The round brush is fitted over the 16 mm
curling tongs, and the spiral curler
attachment over the 25 mm curling tongs.
- The round brush is designed for shaping
the hair. To achieve this, the hair should
be divided into single strands (not too
thick) and then spread evenly over the
brush, turning them inwards or outwards
as desired.
- Apply for a few seconds at a time only,
while allowing the hot air to take effect on
the hair. Let the strands uncurl
afterwards.
- Let the hair cool down sufficiently before
brushing it out.
10