Garland 790 QG Manuel D'instructions page 40

English
Wear glasses and gloves.
Do not clean the material with the engine running.
Stop the engine before clean up. Use shovel, rake or
other tool extensible. Never your hands and feet.
Before start operating, check the wind direction to
not work face to the gases.
Switch off the machine before refuel.
To move the machine pick it fi rmly grips of both
hands,turn the wheel with your foot, lift the
machine, pay attention to the central bar of the
machine and walk slowly.
7.1. HOW TO WORK WITH THIS MACHINE
7.1.1. CUTTING LOGS
The long logs such as sunfl owers, corn and tree
branches are introduced by cutting the side tube
(nozzle) to be cut with the blade rotating.
Some logs will be pushed into the blades with the
following logs, never use your hands.
The last log can be pushed with a stick of wood
ever with their own hands.
Do not push the small branches with their hands,
use wooden sticks.
When you enter the branches, make sure the
thicker branches are to be pushed more slowly
than thin.
Do not overfeed and do not feed wet, soggy
material into the shredder as this may clog the
blade chamber and the discharge chute.
7.1.2. CRUSHED TWIGS AND LEAVES
Leaves, twigs, grass and similar materials must be
placed in the crusher in lots intertwined.
Do not open the plastic cover when you add more
material.
Do not push the leaves and similar material with
their hands, use wooden sticks.
7.2. OBSTRUCTION
7.2.1. INTAKE OBSTRUCTION
Never uses your hands if there is a plug
in the hopper. Use a branch
7.2.2. OUTPUT OBSTRUCTION
Do not overfeed and do not feed wet, soggy
material into the shredder as this may clog the
blade chamber and the discharge chute. An
obstruction can be form between the crushing
hammers and the strainer metal plate
To clear the obstruction you will have to dismantle the
strainer following the next procedure:
40/148