Starting The Engine; Warm Engine Start; Stop The Engine; Machine Usage - Garland 790 QG Manuel D'instructions

6.4.2. STARTING THE ENGINE

Before starting engine make sure check the engine oil
and fuel tank before starting the engine.
6.4.2.1. COLD-STARTING THE ENGINE
A. Place the ON/OFF switch in the "ON" position.
B. Place the fuel tap in the open position.
C. Place the air lever in the Closed position
D. Place the accelerator lever in the maximum
position .
E. Pull the starter grip until the engine starts up and
go past the air lever slowly to the OPEN position
(normal working position). Put the throttle lever
in the down position and let the engine warm for
1 minute before starting to work.
Normal working
position

6.4.2.2. WARM ENGINE START

Follow the A & B steps on the Cold engine start. Move
. the throttle to middle position and pull the starter grip
until it starts.

6.4.2.3. STOP THE ENGINE

Move the throttle lever to the down position and the
engine switch OFF. If you put the Shredder away,
move the lever to the passage of gasoline in the OFF
position.

7. MACHINE USAGE

Make sure the plastic cover over the hopper is closed
when the shredder is running. Splinter can jump and
be dangerous.
Do not put your face or hands in the hopper.
Keep your face and body away from the hopper.
Not stand in front of the discharge chute and not
try to open while the machine is operating.
39/148
Throttle level
Turtle = Minimum
Hare = Maximum
English