Avoid Service Checklist - Kenmore 970L8191 Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Avoid Service Checklist

Before calling for service, review this list. It may save both time and expense. The list includes common occurrences that are
not the result of defective workmanship or materials in this dryer.
OCCURRENCE
POSSIBLE CAUSE
Dryer does not
Electrical power cord is not securely plugged
start.
in or plug may be loose.
House fuse blown or circuit breaker tripped.
Dryer runs but
There are 2 house fuses in the dryer circuit. If 1
won't heat.
of the 2 fuses is blown, the drum may turn but
the heater will not operate.
Drying cycle takes
Lint fi lter is clogged with lint.
too long, outside
of the dryer feels
Electric dryer is connected to a 208 volt
too hot or smells
circuit.
hot.
Drying procedures have not been followed.
High humidity.
Dryer stops during
Water container was not emptied between
a cycle and
cycles and is full.
symbol is lit on
control panel.
Excessive wrin-
Dryer is overloaded.
kling.
Items left in dryer too long.
Insuffi cient sorting of items.
Drying temperature too high.
Scratching or
Foreign objects such as coins, pins, clips or
chipping of the
buttons are inside the dryer.*
drum fi nish.
Permanently attached items such as belt
buckles, zippers and fasteners may be hitting
the inside of the drum.*
*Drum damage caused by foreign objects or permanently attached items is not covered by the warranty.
Solutions to Common Problems
SOLUTION
Make sure the plug fi ts tightly in wall outlet.
Reset circuit breaker or replace fuse.
Make sure electrical line is not overloaded and the
dryer is on a separate circuit.
Replace fuse.
Make sure all lint has been removed from the dryer
lint fi lter before starting each cycle.
Drying time will be 20% longer than drying on a
240 volt circuit.
See "Operating Instructions."
Use a dehumidifi er near the dryer.
Empty and replace water container and restart dryer.
Do not overload. See "Operating Instructions."
Remove items as soon as cycle ends.
See "Operating Instructions."
Follow fabric care label instructions.
Always remove foreign objects from pockets before
laundering. Remove objects from drum and restart
dryer.
It may be necessary to sew a scrap of material
securely around ornaments before drying to prevent
scratching and damage to the dryer.
19

Publicité

Chapitres

Table des Matières
loading

Table des Matières