Preventive Maintenance - CM 5600 Manuel D'entretien

Maintenance (Continued)

PREVENTIVE MAINTENANCE

In addition to the inspection proce-
dures, a preventative maintenance
program should be established to
prolong the useful life of the hoist
and maintain its dependability and
continued safe use. The program
should include the periodic inspec-
tions with particular attention being
paid to the lubrication of various
components using the recommended
lubricants (See Figure 8).
ITEM
Inspector's
Signature
Figure 7 - Recommended Inspector's Report
KEY NO. COMPONENT
(SEE PAGES
(12 & 13)
656-28 Load Chain
656-11
656-12 Bearing Surfaces
656-13
656-17
Hook Knobs
* This lubrication schedule is based on a hoist operating in normal environment conditions. Hoists operating in adverse
atmospheres containing excessive heat, corrosive fumes or vapors, abrasive dust, etc., should be lubricated more frequently.
** See page 12 for ORDERING INSTRUCTIONS.
Figure 8 - Recommended Lubrication Schedule
8
TESTING
Prior to initial use, all repaired or
used hoists that have not been oper-
ated for the previous 12 months
shall be tested by the user for proper
operation.
Test the unit first in the unloaded
state and then with a light load of
100 pounds times the number of
load supporting parts of load chains
to be sure it operates properly and
the brake holds the load when the
hand chain is released; then test
with a load of 125% of its rated
capacity.
REMARKS (LIST DEFICIENCIES AND RECOMMENDED ACTION)
Date
Inspected
RECOMMENDED LUBRICATION SCHEDULE*
CM HURRICANE HAND HOIST
TYPE OF LUBRICANT ** ORDER
®
Lubriplate
Chain Oil 10-R
Gears and
Molykote BR-2-S,
of Upper Molytex #2 or
and Lower TopMoly
INSPECTOR'S REPORT
Approved by
PART NO.
Bar and 28619
(1 gal. can)
28618
(1 lb. can)
In addition, hoists in which load sus-
taining parts have been replaced
must be tested with 125% of rated
capacity by or under the direction of
a designated person and a written
report prepared for record purposes.
NOTE: For additional information on
Inspection and Testing refer to ASME
B30.16,"Overhead Hoists", obtain-
able from ASME Order Department,
22 Law Drive, Box 2300, Fairfield, NJ
07007-2300, U.S.A.
Date
TYPE OF SERVICE AND
FREQUENCY OF LUBRICATION
HEAVY NORMAL
Daily Weekly
When hoist is disassembled for cleaning
or repairs
INFREQUENT
Monthly