Recommended Spare Parts; Preventative Maintenance - CM Tornado 360 Manuel D'entretien, D'opération Et De Pièces

LOAD LIMITER REPLACEMENT AND REPAIR
When disassembling and re-assembling the units, follow all appropriate instructions so that all parts are properly installed. Please refer to
the maintenance section of the this O&M Manual and the supplement instructions provided with the Load Limiter Adjustment Tool (sold
separately).

RECOMMENDED SPARE PARTS

Ratchet Disc Assembly
Latch Kit
Upper & Lower Hook Assembly
Alterations or modifications of equipment and use of any parts
other than CM TORNADO 360° lever hoist repair parts can lead
®
to dangerous operation and injury.
TO AVOID INJURY:
Do not alter or modify equipment. Do use only CM
360° provided replacement parts.

PREVENTATIVE MAINTENANCE

In addition to the inspection procedures, a preventative maintenance program should be established to prolong the useful life of the hoist
and maintain its dependability and continued safe use. The program should include the periodic inspections with particular attention being
paid to the lubrication of various components using the recommended lubricants (See Figure 13).
TESTING
Prior to initial use, all repaired or used hoists that have not been operated for the previous 12 months shall be tested by the user for proper
operation. Test the unit first in the unloaded state and then with a light load of 100 pounds (45 kg.) times the number of load supporting parts
of load chain to be sure it operates properly and the brake holds the load when the lever is released; then test with a load of 125% of rated
capacity.
In addition, hoists in which load sustaining parts have been replaced must be tested with 125% of rated capacity by or under the direction of
a designated person and a written report prepared for record purposes.
NOTE: For additional information on Inspection and Testing refer to ASME B30.21 "Manually Lever Operated Hoists" obtainable from ASME
Order Department, 22 Law Drive, Box 2300, Fairfield, NJ 07007-2300, U.S.A.
ITEM
Inspector's
Signature
Figure 12 - Recommended Inspector's Report
REFERENCE NO.
COMPONENT
(SEE PAGES 11&12)
32 Load Chain
Gears, Bushings, Lift-
5, 1, 8, 24 & 7 wheel bushings & Pinion
(*) This lubrication schedule is based on a hoist operating in normal environment conditions. Hoists operating in adverse atmospheres containing excessive heat, corrosive fumes or vapors,
abrasive dust, etc., should be lubricated more frequently.
Figure 13 - Recommended Lubrication Schedule
® TORNADO
INSPECTOR'S REPORT
REMARKS (LIST DEFICIENCIES AND RECOMMENDED ACTION)
Date
Inspected
RECOMMENDED LUBRICATION SCHEDULE*
CM TORNADO 360° HAND OPERATED LEVER HOISTS
®
TYPE OF LUBRICANT
Oil (See page 8)
Grease (See page 8)
shaft
Approved by
ORDER PART NO. TYPE OF SERVICE AND FREQUENCY OF LUBRICATION
HEAVY
28619 (1 gal. can)
28618 (1 lb. can) When hoist is disassembled for cleaning or repairs
13
(ENGLISH)
Date
NORMAL INFREQUENT
Daily Weekly Monthly
P/N: 192034281 Rev AF Oct 2018