Yealink IP DECT W56P Mode D'emploi page 4

E
N
G
The following item is optional accessory:
L
I
S
H
Note: You need to purchase separately if required.
Assembling the DECT Phone
Assembling the Phone
1. Connect the network and power for the base station in one of the following ways,
as shown below:
a. AC Power Option
Note: If inline power (PoE) is provided, you do not need to connect the power adapter. Make
sure the hub/switch is PoE-compliant. The base station should be used with original
power adapter (5V/600mA) only. The use of the third-party power adapter may cause
the damage to the base station.
2. Insert the battery into the handset, as shown below:
2
W56P Handset Protective Case
b. PoE (Power over Ethernet) Option
battery
IEEE 802.3af compliant
PoE Hub/Switch