Battery Charging - Bosch Professional GSB 12 VE-2 Notice Originale

OBJ_BUCH-525-001.book Page 10 Monday, October 29, 2007 8:56 AM
10 | English
Combination Cordless Drill
Article number
Rated voltage
No-load speed
– 1st gear
– 2nd gear
Impact rate
Torque adjustment range
Max. torque for hard/soft
screwdriving application
according to ISO 5393
Max. drilling dia.
– Steel
– Wood
– Brickwork
Max. screw dia.
Chuck clamping range
Drill spindle thread
Weight according to
EPTA-Procedure 01/2003
Please observe the article number on the type plate of your power tool. The trade names of individual tools may vary.
Assembly

Battery Charging

A new battery or a battery that has not been used
for a longer time produces full power only after
approximately five charge/discharge cycles.
To remove the battery 6, press the unlocking but-
tons 8 and pull out the battery downwards. Do
not exert any force.
The battery is equipped with an NTC tempera-
ture control which allows charging only within a
temperature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.
1 609 929 M33 | (29.10.07)
GSB 12 VE-2 GSB 14,4 VE-2
Professional Professional
0 601 913 5.. 0 601 913 4..
V= 12
0 – 500
rpm
rpm 0 – 1700
0 – 21000
spm
Nm 1.5 – 9
Nm 60/22
mm 13
mm 30
mm 10
mm 8
1.5 – 13
mm
1/2"
kg 2.6
Auxiliary Handle (GSB 18 VE-2/
GSB 24 VE-2/ GSR 18 VE-2/
GSR 24 VE-2) (see figure A)
Before any work on the power tool (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the center posi-
tion. Unintentional actuation of the On/Off
switch can lead to injuries.
Operate your power tool only with the auxil-
iary handle 9.
The auxiliary handle 9 can be set to any position
for a secure and low-fatigue working positure.
Turn the bottom part of the auxiliary handle 9 in
counterclockwise direction and swivel the auxil-
iary handle 9 to the desired position. Then re-
tighten the bottom part of the auxiliary handle 9
by turning in clockwise direction.
The clamping band 11 of the auxiliary handle
must be seated in the corresponding groove.
GSB 18 VE-2
Professional
0 601 913 3..
14.4 18
0 – 500 0 – 500
0 – 1750 0 – 1800
0 – 21000 0 – 21000
1.5 – 9 1.5 – 9
65/24 70/28
13 13
32 35
12 14
8 10
1.5 – 13 1.5 – 13
1/2" 1/2"
2.7 3.0
Bosch Power Tools
GSB 24 VE-2
Professional
0 601 913 2..
24
0 – 500
0 – 1800
0 – 21000
1.5 – 9
75/34
16
38
16
12
1.5 – 13
1/2"
3.2