DeWalt PATMI P1000 Manuel D'instructions page 8

Model P1000
Troubleshooting
alWayS check inSTRucTion Manual FoR pRopeR aSSeMBly oF paRTS
pRoBleM
Fastener Overdriving
Tool does not fire
Tool does not depress
completely
Power reduction or
inconsistent fastener
penetra tion
Powder load will not eject
after firing tool
Load strip cannot be
inserted into tool
Load strip will not
advance
Load will not fire when
trigger is pulled
Load will not fire when
tool is fully depressed and
trigger is pulled
Tool cannot be opened
or cycled
Piston stuck in the
forward position
Chipped or damaged
piston
Piston guide will not
open easily
Piston guide opens too
easily
P1000
poSSiBle cauSe
Power level too high / Pin too short
Soft base material
Tool not depressed completely
Firing pin damaged
Damaged firing pin parts, ejector, etc. Parts
assembled improperly
Barrel is not pulled fully forward when cycling
tool.
Worn or damaged piston
Barrel is not pulled forward completely when
tool is cycled
Bent Piston or damaged piston ring
Build-up of dirt in breech
Improper loading
Wrong caliber strip
Worn advance lever guide
Tool is not fully depressed
Load is already fired
Load misfire
Broken firing pin
Broken or missing
Lack of proper cleaning
Damaged or bent piston
Broken or damaged parts
Piston has been overdriven and is jammed
against piston reset pin
Tool not held on work surface squarely.
This allows the piston to slip off the head of the
pin and cause damage to the piston
Bent shear clip
Excessive build-up of dirt
Piston stop is damaged
Foreign material jammed between the piston
guide and steel liner assembly
Annular ball spring or steel annular ball have
worn
SoluTion
Use a lower powder load level number
or a longer pin
Check base material suitability section
See "Tool does not depress completely"
section below
Replace damaged part(s)
Check the parts for damage or improper assembly
Barrel must be pulled out completely to properly
reset the piston
Replace piston or piston ring
Firmly snap the tool open.
If necessary dismantle and clean
Remove and replace piston or piston ring
Clean breech area
Insert strip from the bottom of the tool handle
Use proper strip
Replace advance lever guide. This should be
performed by qualified individuals
Follow safety procedure for misfired load then
attempt to fully depress tool before pulling trigger
Cycle tool
Follow safety procedure
Replace firing pin nut. This should be performed by
qualified individuals
Replace firing pin nut. This firing pin nut should be
Clean tool thoroughly
Remove and replace piston
Tag tool with warning "Defective - Do Not Use"
place in locked container and contact your D
Authorized representative for service
Tap the piston against a hard surface
Machine piston as shown on page ?. Piston
regrinding may be performed only by
qualified individuals
Remove and replace shear clip
Disassemble and clean tool
Replace piston stop
Disassemble and remove foreign particles
Remove and replace with a new spring and/or ball
8
Cat. No. ddF211000P
WALT
E