Publicité
Les langues disponibles
Les langues disponibles
MAKING ICE CUBES
STEP
: PREPARATION OF THE UNIT
1
Always put the unit on a flat, dry and uncluttered surface (leave a
clearance of
cm around your unit).
15
STEP
: CLEANING OF THE TANK AND THE SYSTEM
2
The water tank and the system must be cleaned before use.
To clean the tank, fill it with water (see step
*
drain plug to let the wastewater drain out (see step
water out.
Then plug in your unit and fill the tank with clean water (see
*
step
), press the ice cube size selection button for three seconds
3
to activate the function of automatic cleaning of the system.
Once the
cleaning cycles are finished, drain off this water through
5
the drain plug (see step
). Throw this water out.
9
3
) and then open the
). Throw this
9
50
STEP
: FILLING OF THE TANK
3
Remove the ice cube dish.
Fill the tank, making sure that you do not go beyond the maximum
level indicated by the line and the "MAX" marking.
N.B. You can accelerate the ice cube making process by using very
cold water.
Be sure to change the water once a day. If the unit is not
used for a long period of time, you must replace the water.
The tank's capacity is
.
L.
2
1
Put the ice cube dish back in place and close the cover..
STEP
: PROGRAMMING
4
Press the On/Off button to start your unit.
Choose the ice cube size (small or large), by successively pressing
the ice cube size selection button. The default size is the largest size.
Select the smallest size when the ambient temperature is below
15
°C and the largest size when the ambient temperature is higher
than
°C.
30
Press the On/Off button to start making ice cubes.
Publicité
