Télécharger Imprimer la page

Lagrange Glacon Express' Notice page 44

Publicité

Les langues disponibles

Les langues disponibles

SAFETY INSTRUCTIONS
Read these instructions carefully and keep them
for future reference.
Always unwind the cord completely.
*
If the power cable is damaged, in order to avoid
*
any danger it must be replaced by
its after-sales service or persons with similar
qualifications approved by
Put the unit on a flat and dry surface.
*
Never put your unit on a hot surface or near a flame.
*
Plug in the unit to a 10 / 16 A socket equipped with
*
a ground connection.
It is recommended that you connect the unit to a
*
system that has a differential residual current system
with a breaking current not exceeding 30 mA.
If you must use an extension cord, always use a
*
model equipped with a ground and with wire of
section greater than or equal to 0 . 75 mm ² .
This appliance can be used by children aged from 8
*
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision
or instruction concerning use of the appliance in
a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children
unless they are older than 8 and supervised.
Keep the unit and the power cord out of reach of
*
children under the age of eight.
Never put your unit into water or any other liquid.
*
Never pour water onto the cord, the plug or the
,
aeration vents of the unit.
For your safety, it is recommended that you never
*
.
leave the unit in a place exposed to foul weather
and moisture.
Do not use the unit outside.
*
Before any handling, unplug the unit.
*
Do not move the unit when it is operating.
*
Do not embed the unit.
*
Never cover the unit with a cloth when it is operating.
*
Do not drop the unit as it could be damaged
*
Do not use any accessory that is not supplied with
*
the unit during its functioning.
These units are not intended to be operated by
*
means of an exterior timer or by a separate remote
control system.
When the unit is not being used or is left without
*
surveillance and before assembly, dismantling or
44

Publicité

loading