Atlantic THEOLA DIGITAL Notice D'installation Et D'utilisation page 35

There is an automatic inactivity timeout on the control panel display after a few seconds,
with the exception of the heating indicator, which is lit when the resistor power supply is on.
It is possible to configure the panel so that the indicator goes out when the panel display is
switched off.
1 - Press and hold the
display .
2 - Press twice to display
3 - Press , will flash alternately with
4 - Press to display
5 - Press to exit.
X2
It is possible to reset the radiator, erasing all the settings made (programs, calibration,
maximum temperature, heating indicator). This function is particularly useful in case of
programming errors.
1 - Press and hold the
display .
2 - Press three times to display
3 - Press , will flash alternately with
4 - Press to display
5 - Press to confirm. All the indicators will light up. The radiator will then return to
manual mode at 19°C.
X3
To increase the appliance's service life and optimise its operation, there is an automatic
bleed built into the upper part of the towel dryer radiator frame.
This operates completely autonomously, with no user operations required.
HEATING STANDBY INDICATOR
and buttons at the same time for more than 3 seconds to
(Heating Indicator).
.
FACTORY SETTINGS
and buttons at the same time for more than 3 seconds to
(Factory Settings).
.
Automatic bleed
.
.
35
EN