Cannon OPTIMUM Instructions D'installation page 8

INSTALLING ThE BASE
INSTALL ATION
INSTALLING ThE BASE
1
Item(s) needed:
a. Review the mounting considerations at the
beginning of the installation and select a mounting
location. Make sure the downrigger is not
connected to a power source.
Make sure the downrigger is not connected to a power source.
b. Take the Mounting Base (Assembly #C) and
attach it to the Downrigger Assembly (Assembly
#A). The Mounting Base is keyed with the bottom
of the Downrigger Assembly. The Soft Grip Knob
on the Mounting Base screws into a metal plate on
the bottom of the Downrigger Assembly. Secure the
Mounting Base to the Downrigger Assembly so that
the Soft Grip Knob is in the correct position.
c. In the final Installation, the Mounting Base is
installed on the Swivel Base (Assembly #B). If
desired, hold the Downrigger Assembly (Assembly
#A) with the Swivel Base at the selected mounting
location to check fit and function. Use a second
person to help with the installation and test to make
sure that the downrigger will operate as desired.
d. Determine if a mounting accessory, such as a
recommended deck plate is needed. Refer to
the installation instructions included with any
mounting accessory and then complete the
downrigger installation.
NOTICE: This downrigger weighs approximately
19 lbs. We recommend having a second person help
with the installation.
NOTICE: The Release Knob on the Swivel Base can
face any direction for your final installation.
8
#A x 1
WARNING
#C x 1 #B x 1
Downrigger Downrigger
1a
Assembly Assembly
Power Cable Power Cable
1b
Downrigger Downrigger
Assembly Assembly
Metal Metal
Plate Plate
1b
1c
Release Knob Release Knob
|
© 2021 Johnson Outdoors Marine Electronics, Inc.
Power Power
Cable Cable
Downrigger Downrigger
Soft Soft
Assembly Assembly
Grip Grip
Knob Knob
Metal Metal
Mounting Base Mounting Base
Plate Plate
Downrigger Downrigger
Assembly Assembly
Mounting Base Mounting Base
Swivel Base Swivel Base
Mounting Mounting
Location Location
|
cannondownriggers.com