Cannon OPTIMUM Instructions D'installation page 23

2
Item(s) needed:
#20 X 1 or 2
c. A Soft Grip Knob will be used to secure the Dual
Axis Rod Holder Tube to the Arm just installed.
Take one or two Soft Grip Knobs (Item #20) and
one or two Spring Releases (Item #22). Place one
spring on the end of each Soft Grip Knob.
d. Take the Dual Axis Rod Holder Tube (Item #24)
and turn it so that the short end of the piece will
be placed against the Dual Axis Rod Holder Arm.
The face of the Dual Axis Rod Holder Arm that
contains keyed teeth which are matched on the
Dual Axis Rod Holder Tube. These keyed teeth will
help to hold the position of the knob and help to
hold it in place when the position of the holder
is changed during use. Secure the Dual Axis Rod
Holder Tube with the Soft Grip Knob.
e. To adjust the direction of the Dual Axis Rod Holder
Arm or tube, loosen the Soft Grip Knob and rotate
in the desired direction. Then re-tighten the Soft
Grip Knob to secure in place.
NOTICE: The Soft Grip Knobs and Spring Releases will
be inside the Dual Axis Rod Holder Tube.
|
© 2021 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE REAR MOUNT ROD HOLDER
#22 x 1 or 2
|
cannondownriggers.com
#34 X 1
2c
Soft Grip Knob Soft Grip Knob
Spring Release Spring Release
2d
Soft Grip Soft Grip
Knob Knob
Short End Short End
Dual Axis Dual Axis
Rod Holder Rod Holder
Arm Arm
2e
Soft Soft
Grip Grip
Knob Knob
Soft Grip Soft Grip
Knob Knob
Dual Axis Rod Dual Axis Rod
Holder Arm Holder Arm
2c
Spring Release Spring Release
Soft Grip Knob Soft Grip Knob
Dual Dual
Axis Rod Axis Rod
Holder Holder
Tube Tube
23