Cannon OPTIMUM Instructions D'installation page 15

7
k. Secure the orientation of the Ball Hook by turning
the Hex Nut on the Ball Hook Assembly until it is
seated tightly against the Ball Hook Extrusion with
a 7/16" wrench. Hand tighten until secure.
INSTALLING ThE SWIVEL hEAD/BOOM END
1
Item(s) needed:
#28 x 1
a. Next install the Boom End (Assembly #K) on the end
of the Telescopic Boom. Take the Boom End and find
the mounting hole along the shaft. The mounting
hole in the Shaft of the Boom End should be aligned
with the mounting hole in the Center Tube at the
narrow end of the Telescopic Boom.
b. Once aligned, take the #8-18 X 5/8" Screw (Item
#28) and insert it into the end of the Boom
Assembly. Secure the screw with a Phillips Head
screwdriver by turning clockwise.
|
© 2021 Johnson Outdoors Marine Electronics, Inc.
INSTALLING ThE SWIVEL hEAD/BOOM END
#K x 1
|
cannondownriggers.com
Ball Hook Extrusion Ball Hook Extrusion
7k
Telescopic Telescopic
Boom Boom
Hex Hex
Nut Nut
Downrigger Downrigger
Assembly Assembly
Ball Hook Ball Hook
1a
Center Tube Center Tube
Telescopic Boom Telescopic Boom
1b
Center Tube Center Tube
Telescopic Telescopic
Boom Boom
Ball Hook Extrusion Ball Hook Extrusion
7k
Telescopic Telescopic
Boom Boom
Hex Hex
Nut Nut
Downrigger Downrigger
Assembly Assembly
Ball Hook Ball Hook
Boom End Boom End
Shaft Shaft
Mounting Mounting
Holes Holes
Wide End Wide End Narrow End Narrow End
Boom Boom
End End
15