Publicité
T EC HN I C A L INF O RM AT IO N
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
Hole size in mounting surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water
heater.
I N STALL ATI ON CO N SI DE R AT I ON S
⁄ For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
⁄ Inspect this faucet thoroughly before installation.
Claims for shipping damage made after installa-
tion will not be honored.
⁄ Please read over these instructions thoroughly be-
fore beginning installation. Make sure that you
have all tools and supplies needed to complete
the installation.
⁄ The drain is suitable for most, but not all, lavatory
sinks sold in the United States and Canada.
⁄ This drain is intended for use in a sink with an over-
flow. If your sink does not have an overflow, or
if this drain is too small for the hole in your sink,
please refer to the instructions included with the
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (4.5 L/min)
1⅜" (36 mm)
15/8" (40 mm)
E N G L I S H
sink. Some sinks include special drain installation
instructions and/or parts. Others require the use of
a specialty drain. Hansgrohe is not respnsible for
the cost of a specialty drain.
The hot and cold supply hoses included with
this faucet are for use with ⅜ stops. If your
stops are a different size, install new stops.
Adapters are not available from Hansgrohe.
⁄ Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicité
