Elica INTEGRATA Notice De Montage Et Mode D'emploi page 15

In order to use the hood in this version, you have to install a system of
additional filtering based on activated charcoal.
The models with no suction motor only operate in ducting mode, and
must be connected to an external suction device (not supplied).
The connecting instructions are supplied with the peripheral suction unit.
Mounting
Expansion wall plugs are provided to secure the hood to most types of
walls/ceilings. However, a qualified technician must verify suitability of
the materials in accordance with the type of wall/ceiling. The wall/ceiling
must be strong enough to take the weight of the hood.
Do not tile, grout or silicone this appliance to the wall. Surface
mounting only.
Before beginning installation:
• Check that the product purchased is of a suitable size for the
chosen installation area.
• Remove the charcoal (*) filter/s if supplied (see also relative
paragraph). This/these is/are to be mounted only if you want lo use
the hood in the filtering version.
• Check (for transport reasons) that there is no other supplied
material inside the hood (e.g. packets with screws (*), guarantees
(*), etc.), eventually removing them and keeping them.
Operation
Use the keys or buttons envisaged for the control of the lights and the
power of the available suction.
Only in some models: switching on and off the fan that adjusts the
suction power and, in some cases, switching the lights on and off, is
controlled by opening and closing the steam collector.
If your product is provided with an electrically or mechanically activated
valve, the keys and/or the buttons and/or the handles available are for
controlling the lights and for opening and closing the valve.
Maintenance
Cleaning
Clean using ONLY a cloth dampened with neutral liquid detergent. DO
NOT CLEAN WITH TOOLS OR INSTRUMENTS. Do not use
abrasive products. DO NOT USE ALCOHOL!
Grease filter
Fig. 2-17
Traps cooking grease particles.
If situated inside the support grill, it may be one of the following types:
Paper filter must be replaced once a month or if colouring appears on
upper side, in such cases the colouring is evident through the grill
openings.
Metallic filter must be cleaned once a month, with non abrasive
detergents, by hand or in dishwasher on low temperature and short
cycle.
When washed in a dishwasher, the grease filter may discolour slightly,
but this does not affect its filtering capacity.
Charcoal filter (filter version only)
Fig. 16
It absorbs unpleasant odors caused by cooking.
The saturation of the charcoal filter occurs after more or less prolonged
use, depending on the type of cooking and the regularity of cleaning of
the grease filter.
In any case it is necessary to replace the cartridge at least every four
mounths (or when the filter saturation indication system – if envisaged
on the model in possession – indicates this necessity).The charcoal filter
may NOT be washed or regenerated.
Remove the grill.
Apply the carbon filter to cover the grill that protects the suction motor
and turn the carbon filter clockwise to block it (bayonet fixed).
Put the grill back.
Reverse dismantling.
Note: 2 filters are needed in the models with 2 motors. The system of
montage and dismantling is identical.
Replacing lamps
Disconnect the appliance from the electricity.
Warning! Prior to touching the light bulbs ensure they are cooled down.
Remove the suction gril to access the lamp area.
Replace the damaged lamp.
Use E14 3W max LED lamps only. For more details, check enclosed
leaflet "ILCOS D" (alfanumeric position "1d").
On some models ONLY:
A Non Return Backdraft Damper is included in the supply, as optional
accessory to be installed under certain installation conditions (i.e. if there
is no protection against accidental backdraft of air from the outside). The
damper must be installed inside the dedicated housing, inside of the Air
Outlet Fitting, before installing the flue.
15