Publicité
T EC HN I C A L I N FO RMATIO N
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
spout
handshower
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
I NSTALL ATI ON CO N SIDE R ATION S
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
⁄ This trim is for use with rough 10452181 (not in-
cluded). The rough must be installed and the finished
floor surface completed and made watertight.
T hi s un it is no t a nti-s cal d. If re qu ired
b y loc al c o de , insta ll in co m bin atio n
wi t h an a p p rov e d remo t e pre ssu re bal -
a n ce v al v e o r o the r a ppr o ved t empe rin g
de vi ce .
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
5.8 GPM (22 L/min)
1.75 GPM (6.6 L/min)
E N G L I S H
⁄ Protection against backflow is provided by check
valve and an automatically resetting diverter.
⁄ This showerhead is for use with an automatically
compensating valve rated at 1.3 GPM (4.9 L/min)
or less.
⁄ To prevent scald injury, the maximum output tem-
perature of the shower valve must be no higher than
120°F (49°C). In Massachusetts, the maximum
output temperature can be no higher than 112°F
(44°C).
⁄ Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a
safe place. The receipt is required should it be neces-
sary to request warranty parts.
Publicité
